Forming process and evaluation of chip in machining of high-strength steel by an independent-developed microgroove turning tool
Authors:
Open Access
- 19 July 2021
- journal article
- research article
- Published by SAGE Publications in Science Progress
- Vol. 104 (3)
Abstract
Chip morphology is one of the evaluation indexes of cutting performance of cutting tools, and chip forming process has a direct and important influence on chip morphology. High-strength steel 40CrMnMo is one of typical oil country tubular goods (OCTG) and difficult-to-cut materials, and its chip morphology represents the machining quality of OCTG. The chip forming process of a new independent-developed microgroove turning tool for turning oil country tubular goods 40CrMnMo is researched, combining machining experiments with theoretical analysis. Research results show that with the increase of cutting speed, the initial radius of curvature of the chip fluctuates slightly, but the overall trend is upward. However, the ultimate radius of curvature decreases and the chip’s radius ratio also decreases. The relative ideal chip can be obtained if the proper cutting velocity and feed rate are given. Chip morphology results from the comprehensive effect of the two processes: The fracture and separation process of the workpiece during passing through the shear deformation zone and the process of curling and breaking away of the chip after passing through the rake face of the tool. The research results have a certain guiding significance for controlling the cutting process of machining the other material with similar performance.Keywords
Funding Information
- Guizhou Institute of Technology (2019066)
- Young Scientific Technical Talents Development Fund of Guizhou Province (QJHKY Character [2018]248)
- National Natural Science Foundation of China (52005118)
This publication has 30 references indexed in Scilit:
- Finite element modeling of chip separation in machining cellular metalsAdvances in Manufacturing, 2015
- Role of phase transformation in chip segmentation during high speed machining of dual phase titanium alloysJournal of Materials Processing Technology, 2014
- Monitoring the tool wear, surface roughness and chip formation occurrences using multiple sensors in turningJournal of Manufacturing Systems, 2014
- Effect of Ultrasonic Vibrations on Chip–Tool Contact Zone in Turning of AISI304Materials and Manufacturing Processes, 2014
- Shear Deformation in Chip Particulates Produced Using Modulation Assisted MachiningMaterials and Manufacturing Processes, 2014
- On the mechanics of chip formation in Ti–6Al–4V turning with spindle speed variationInternational Journal of Machine Tools and Manufacture, 2014
- Modeling of velocity-dependent chip flow angle and experimental analysis when machining 304L austenitic stainless steel with groove coated-carbide toolsJournal of Materials Processing Technology, 2013
- Effects of built-up edge-induced oscillations on chip formation during turningJournal of Sound and Vibration, 2013
- Theoretical and experimental investigation of the frictional behavior of the tool–chip interface in ultrasonic-vibration assisted turningInternational Journal of Machine Tools and Manufacture, 2013
- SOM based Methodology for Evaluating Shrinkage Parameter of the Chip Developed in Titanium Dry Turning ProcessProcedia CIRP, 2013