Effect of hot embossing process parameters on polymer flow and microchannel accuracy produced without vacuum
Authors:
- C. LiuCLC. Liu
- 1 October 2008
- journal article
- research article
- Published by Elsevier in Journal of Materials Processing Technology
- Vol. 207 (1-3) , 163-171
Abstract
No abstract availableKeywords
This publication has 6 references indexed in Scilit:
- Preventing non-uniform shrinkage in open-die hot embossing of PMMA microstructuresJournal of Materials Processing Technology, 2003
- Application of orthogonal experiment in EDM using the suspended powder fluidJournal of Wuhan University of Technology-Mater. Sci. Ed., 2002
- Low-cost thermoforming of micro fluidic analysis chipsJournal of Micromechanics and Microengineering, 2002
- Hot embossing in microfabrication. Part I: ExperimentalPolymer Engineering & Science, 2002
- Flow behaviour of thin polymer films used for hot embossing lithographyMicroelectronic Engineering, 2000
- Hot embossing as a method for the fabrication of polymer high aspect ratio structuresSensors and Actuators A: Physical, 2000