Measurement of Dynamic Magnetic Flux Density Distribution at the Surface of HTS Bulk
- 27 February 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 34 (3) , 1-4
Abstract
Flux pinning in high-temperature superconducting (HTS) bulk is essential for power applications. Since HTS bulk integrated in the motor/generator requires pulse field magnetization (PFM) before operation, evaluating the time evolution of the trapped magnetic flux density distribution is important in the development of power applications. In general, scanning the Hall element over the HTS bulk surface provides a detailed measurement of the magnetic flux density distribution. However, the mechanical scanning speed is too slow relative to the elapsed time of PFM, to obtain information about the transient behavior of the penetration magnetic field. Therefore, we have placed Hall elements at several locations with characteristic crystal structures on the HTS bulk surface and measured the magnetic flux density in a short period of time. In this study, we have constructed a system that can measure the magnetic flux density distribution every approximately 1 ms, which we name a two-dimensional magnetic field sensor (2DMFS) and measured the distribution of the magnetic flux density that enters the bulk during PFM on the HTS bulk surface. The sample is a GdBCO bulk of 45 mm diameter and 19 mm thick, which we used in our axial-gap type HTS rotating machine. In this paper, we'll show the transient magnetic flux density distribution that penetrated the sample during PFM and contrast it with the conventional measurement method.Keywords
Funding Information
- JSPS KAKENHI (JP20K21044)
This publication has 11 references indexed in Scilit:
- Waveform Control Pulse Magnetization of GdBaCuO Bulk Near Operating Temperature of Our Superconducting Rotating MachineIEEE Transactions on Applied Superconductivity, 2022
- Improvement of trapped magnetic field in GdBCO by waveform control pulse magnetization at 70 KJournal of Physics: Conference Series, 2020
- Core Loss of a Bulk HTS Synchronous Machine at 2 and 3 T Rotor MagnetisationIEEE Transactions on Applied Superconductivity, 2019
- Two-Dimensional Measurement Technique for Dynamic Magnetic Flux Density Distribution on the Surface of HTS BulkIEEE Transactions on Applied Superconductivity, 2016
- A trapped field of 17.6 T in melt-processed, bulk Gd-Ba-Cu-O reinforced with shrink-fit steelSuperconductor Science and Technology, 2014
- Trapped Magnetic Flux of Bulk HTS Magnets in the External AC Magnetic Field at Low TemperaturesIEEE Transactions on Applied Superconductivity, 2012
- Mechanical design of a synchronous rotating machines with Gd-Ba-Cu-O HTS bulk pole-field magnets operated by a pulsed-field magnetization with armature copper coilsJournal of Physics: Conference Series, 2006
- An Axial Gap-Type HTS Bulk Synchronous Motor Excited by Pulsed-Field Magnetization With Vortex-Type Armature Copper WindingsIEEE Transactions on Applied Superconductivity, 2005
- High-temperature superconductor bulk magnets that can trap magnetic fields of over 17 tesla at 29 KNature, 2003
- Magnetization of Hard SuperconductorsPhysical Review Letters, 1962