Titanium Nitride as a Strain Gauge Material
- 23 June 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 25 (4) , 683-690
Abstract
The performance of titanium nitride (Ti-N) thin films deposited by reactive magnetron sputtering for use as a strain gauge material was investigated. Films of different composition ranging from pure titanium to over-stoichiometric Ti-N were prepared by varying the nitrogen flow to total flow ratio (α). The atomic composition was measured using Rutherford backscattering spectrometry and energy-dispersive X-ray spectroscopy. The structure of the films was studied using X-ray diffraction and scanning electron microscopy, revealing the formation of a columnar film morphology consisting of cubicTi-N grains with preferential crystal orientations depending on the flow ratio α. The stability of the film resistivity was studied at 200 °C for 360 h. Films deposited at low (α ≤ 0.08) and high (α = 0.60) nitrogen flows exhibited a stable behavior relative to films deposited with intermediate nitrogen flows. The longitudinal piezoresistive gauge factor was found to increase with increasing nitrogen flow before settling at values of 6-6.35. Finally, the temperature coefficient of resistivity was found to be less than 300 ppm/°C for the films with the highest gauge factors. The results demonstrate that the Ti-N films have a good potential as a strain gauge material, especially due to the relatively high gauge factor.Keywords
Funding Information
- Innovation Fund Denmark (the former Advanced Technology Foundation) (127-2013-5)
This publication has 25 references indexed in Scilit:
- Me-DLC films as material for highly sensitive temperature compensated strain gaugesDiamond and Related Materials, 2011
- Celebrating the 100th anniversary of the Stoney equation for film stress: Developments from polycrystalline steel strips to single crystal silicon wafersThin Solid Films, 2009
- Characteristics of tantalum nitride thin film strain gauges for harsh environmentsSensors and Actuators A: Physical, 2007
- Strain sensitivity of TiB2, TiSi2, TaSi2 and WSi2 thin films as possible candidates for high temperature strain gaugesSensors and Actuators A: Physical, 2006
- Thin-film thermocouples and strain-gauge technologies for engine applicationsSensors and Actuators A: Physical, 1998
- Characterization of titanium nitride films prepared by d.c. reactive magnetron sputtering at different nitrogen pressuresSurface and Coatings Technology, 1997
- Reactive magnetron sputtering deposition of TiN films. I. Influence of the substrate temperature on structure, composition and morphology of the filmsSurface and Coatings Technology, 1997
- Characterization of tantalum oxynitride thin films as high-temperature strain gaugesSensors and Actuators A: Physical, 1995
- Ceramic pressure sensor based on tantalum thin filmSensors and Actuators A: Physical, 1994
- Vegard’s lawPhysical Review A, 1991