Features of structural transformations of the heat affected zone metal of high-hardness steels. (Review)
- 30 May 2026
- journal article
- Published by Institute of Ferrous Metallurgy Z.I. Nekrasova of the National Academy of Sciences of Ukraine in Fundamental and applied problems of ferrous metallurgy
- No. 40,p. 166-185
Abstract
A comprehensive metallurgical analysis of alloying of high-hardness (HHA, 450–550 HB) and ultra-high-hardness (UHHA, > 600 HB) armor steels is presented. The main attention is paid to the synergistic and competing effects of the influence of silicon (Si) and aluminum (Al) depending on the thickness of the armor plate, where 20 mm is a critical technological threshold. It is established that for light armor (< 20 mm), under conditions of dominance of the threat of penetration by high-speed shells, the maximum silicon content is a priority to ensure surface hardness. For heavy armor (> 20 mm), the provision of through-hardness and toughness is of paramount importance, which is achieved due to the increased aluminum content to grind austenite grain. The influence of the Al/Si ratio on the balance of hardness, strength, impact toughness and processability, in particular on the stability of the microstructure in the heat-affected zone (HAZ) of the welded joint, is analyzed. The need for a differentiated approach to the choice of the alloying system and optimization of the Al/Si ratio in strict accordance with the thickness of the armor and the expected fracture mechanisms is shown. It is confirmed that silicon Si and aluminum Al critically affect the formation of the structure of the metal of the heat-affected zone (HAZ), and the nature of this influence is determined by the thickness of the armor, providing an optimal balance of mechanical properties at a high level of hardness > 400 HB. The use of silicon Si increases the structural stability of the HAZ metal, while alloying with chromium Cr provides hardness at a level of about 500 HB due to the formation of carbides of the M₇C₃ type. For steels with small armor thicknesses (< 20 mm), the optimal ratio is Al/Si < 0.02. For armor steels with large armor thicknesses (> 20 mm), the optimal ratio of aluminum to silicon shifts towards Al/Si > 0.1. Increasing the aluminum content (up to 0.5 %) is necessary to ensure a fine-grained structure throughout the thickness of the plate.Keywords
This publication has 9 references indexed in Scilit:
- Approaches to enhancing the ballistic performance of welded joints in high and ultra-high hardness armor steels (Review)2025
- Classification of tensile test results of unidirectional carbon fiber-polysulfone composite material based on random forest, KNN and CNN methodsResults in Materials, 2025
- Dendrite Structure, Spot Segregation and Banded Defect of Gear Steel in Continuous Casting and Rolling ProcessMetallurgical and Materials Transactions B, 2023
- Influence of Structural Transformations on the Mechanical Properties of Welded Joints of Armor SteelsMaterials Science, 2021
- Structural Transformations of the Metal of Heat-Affected Zone of Welded Joints of High-Strength Armor SteelsMaterials Science, 2020
- Introduction to armour materials2017
- Metallography and Microstructures2004
- Heat-affected zone softening in high-strength low-alloy steelsJournal of Materials Processing Technology, 1999
- Hydrogen assisted cracking in C-Mn and low alloy steel weldmentsInternational Materials Reviews, 1990