Evaluation of material property estimating methods for n-alkanes, 1-alcohols, and methyl esters for droplet evaporation calculations
Open Access
- 21 May 2021
- journal article
- research article
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 57 (12) , 1965-1979
Abstract
Modeling of heat and mass transfer in liquid fuel combustion requires several material properties in a wide temperature and pressure range. The unavailable data are commonly patched with various estimation methods. In this paper, group contribution methods (GCM) and law of corresponding states (LCS) were analyzed for estimating material properties of n-alkanes (up to C10H22 and C12H26), 1-alcohols (up to C10H22O), and methyl esters (up to C19H38O2 and C19H36O2). These were compared to reference data to evaluate their applicability. LCS suggested by Poling et al. provides proper estimation for the acentric factor. GCM of Joback accurately estimates normal boiling point, critical properties, and specific heat capacity of the vapor-phase, the latter was corrected for methanol, however, GCM of Constantinou is more accurate for critical pressure of methyl esters. GCM of Ruzicka is suitable for estimating liquid-phase specific heat capacity. This method was updated for methanol. GCM of Elbro gives a proper estimation for liquid-phase density, while LCS of Lucas estimates vapor-phase viscosity properly. LCS of Chung and the modified Eucken method for vapor-phase and GCM of Sastri for liquid-phase thermal conductivity are appropriate. Considering the gas-phase mutual diffusion coefficient, the method of Fuller provides the best estimation, while LCS methods of Riedel and Chen are suitable for the enthalpy of vaporization at the normal boiling point.Keywords
Funding Information
- Nemzeti Kutatási, Fejlesztési és Innovaciós Alap (BME-NC, OTKA-FK 124704)
- Emberi Eroforrások Minisztériuma (ÚNKP-18-4-BME-195, ÚNKP-18-3-I-BME-145)
- Innovációs és Technológiai Minisztérium (ÚNKP-19-3-I-BME-236, ÚNKP-19-4-BME-213)
- Magyar Tudományos Akadémia
This publication has 46 references indexed in Scilit:
- Estimation of the acentric factor and the liquid molar volume at 298 K using a new group contribution methodFluid Phase Equilibria, 1995
- Group contribution method for the prediction of liquid densities as a function of temperature for solvents, oligomers, and polymersIndustrial & Engineering Chemistry Research, 1991
- ESTIMATION OF PURE-COMPONENT PROPERTIES FROM GROUP-CONTRIBUTIONSChemical Engineering Communications, 1987
- Die Druckabhängigkeit der Viskosität von Flüssigkeiten – eine einfache AbschätzungChemie Ingenieur Technik, 1981
- New correlations for predicting vaporization enthalpies of pure compoundsThe Chemical Engineering Journal, 1979
- Diffusion of halogenated hydrocarbons in helium. The effect of structure on collision cross sectionsThe Journal of Physical Chemistry, 1969
- The thermal conductivity of nonpolar substances in the dense gaseous and liquid regionsAIChE Journal, 1964
- The Volumetric and Thermodynamic Properties of Fluids. II. Compressibility Factor, Vapor Pressure and Entropy of Vaporization1Journal of the American Chemical Society, 1955
- Kritischer Koeffizient, Dichte des gesättigten Dampfes und Verdampfungswärme. Untersuchungen über eine Erweiterung des Theorems der übereinstimmenden Zustände. Teil IIIChemie Ingenieur Technik, 1954
- Methyl Alcohol: The Entropy, Heat Capacity and Polymerization Equilibria in the Vapor, and Potential Barrier to Internal RotationJournal of the American Chemical Society, 1951