Characterization of Partially Premixed Combustion With Ethanol: EGR Sweeps, Low and Maximum Loads
- 26 May 2010
- journal article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 132 (8) , 082802
Abstract
Exhaust gas recirculation (EGR) sweeps were performed on ethanol partially premixed combustion (PPC) to show different emission and efficiency trends as compared with diesel PPC. The sweeps showed that when the EGR rate is increased, the efficiency does not diminish, HC trace is flat, and CO is low even with 45% of EGR. exponentially decreases by increasing EGR while soot levels are nearly zero throughout the sweep. The EGR sweeps underlined that at high EGR levels, the pressure rise rate is a concern. To overcome this problem and keep high efficiency and low emissions, a sweep in the timing of the pilot injection and pilot-main ratio was done at gross IMEP. It was found that with a pilot-main ratio of 50:50, and by placing the pilot at −60 with 42% of EGR, and soot are below EURO VI levels; the indicated efficiency is 47% and the maximum pressure rise rate is below 10 bar/CAD. Low load conditions were examined as well. It was found that by placing the start of injection at −35 top dead center, the efficiency is maximized, on the other hand, when the injection is at −25, the emissions are minimized, and the efficiency is only 1.64% lower than its optimum value. The idle test also showed that a certain amount of EGR is needed in order to minimize the pressure rise rate.
Keywords
This publication has 11 references indexed in Scilit:
- Partially Premixed Combustion at High Load using Gasoline and Ethanol, a Comparison with DieselSAE International Journal of Advances and Current Practices in Mobility, 2009
- Partially Pre-Mixed Auto-Ignition of Gasoline to Attain Low Smoke and Low NOx at High Load in a Compression Ignition Engine and Comparison with a Diesel FuelSAE International Journal of Advances and Current Practices in Mobility, 2007
- Advantages of Fuels with High Resistance to Auto-ignition in Late-injection, Low-temperature, Compression Ignition CombustionSAE International Journal of Advances and Current Practices in Mobility, 2006
- Characterization of Partially Premixed CombustionSAE International Journal of Advances and Current Practices in Mobility, 2006
- Multiple Simultaneous Optical Diagnostic Imaging of Early-Injection Low-Temperature Combustion in a Heavy-Duty Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2006
- Investigation of Premixed Lean Diesel Combustion with Ultra High Pressure InjectionSAE International Journal of Advances and Current Practices in Mobility, 2005
- Combination of Combustion Concept and Fuel Property for Ultra-Clean DI DieselSAE International Journal of Advances and Current Practices in Mobility, 2004
- Premixed Compression Ignition (PCI) Combustion for Simultaneous Reduction of NOx and Soot in Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2004
- HCCI Combustion in DI Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2003
- Dual Mode Combustion Concept With Premixed Diesel Combustion by Direct Injection Near Top Dead CenterSAE International Journal of Advances and Current Practices in Mobility, 2003