Generation of fibrillar morphology in blends of block copolyetheresteramide and liquid crystal polyester
Authors:
Open Access
- 1 June 1996
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 36 (12) , 1636-1646
Abstract
Polymer blends comprising liquid crystal polymers, LCP, as a minor component can be formed into fibrillar‐type morphology. This morphology enables the generation of improved mechanical properties in the draw direction, in a manner comparable to unidirectional composites: In this paper, the results obtained for blends of a polyetheresteramide block copolymer, PEBA, with a liquid crystalline copolyester are presented. Films prepared using a single‐screw extruder were melt drawn on calendering rolls. The blends' storage modulus increased with draw ratio, λ, reaching a maximum value for λ = 3–4. The storage modulus of blends containing 30 wt% LCP, and drawn to λ = 4 to 12, was found to increase nearly 50‐fold in comparison to neat PEBA (from 18 MPa to almost 1 GPa). The blends' morphology was characterized by dissolving the PEBA matrix, followed by gravimetric and microscopic analysis of the LCP phase. As expected, the average fiber diameter decreased as a function of λ−0.5. The fiber content as a function of λ followed a trend parallel to that of the modulus. Longitudinal and transverse moduli followed the Halpin‐Tsai predictions for unidirectional composites. Properties of compression molded specimens prepared from these blends compared favorably with glass fiber composites.Keywords
This publication has 31 references indexed in Scilit:
- Self-reinforced prepregs and laminates of a poly(phenylene oxide)—polystyrene alloy with a liquid crystalline polymerPolymer, 1995
- Influence of processing history on the properties of a thermotropic copolyester/polycarbonate blendPolymer Engineering & Science, 1995
- Self‐reinforced thermoplastic‐LCP prepregs and laminatesPolymer Composites, 1994
- Fibril formation in in situ composites of a thermotropic liquid crystalline polymer in a thermoplastic matrixJournal of Applied Polymer Science, 1993
- Sheet extrusion of in‐situ composites: Influence of processing parametersPolymer Engineering & Science, 1993
- Fibers from blends of PET and thermotropic liquid crystalline polymerPolymer Engineering & Science, 1993
- Liquid crystalline polymer/fluoropolymer blends: Preparation and properties of unidirectional “prepregs” and composite laminatesPolymer Engineering & Science, 1993
- Rheological and physical properties of polyarylate/LCP blend systemsPolymer Engineering & Science, 1993
- Formation of high melting crystal in a thermotropic aromatic copolyesterMacromolecules, 1988
- Production of ultrahigh-modulus liquid-crystal polymer rodsJournal of Polymer Science Part B: Polymer Physics, 1988