Distribution of striation thickness from impingement mixers in reaction injection molding
Authors:
- 1 July 1983
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 23 (10) , 556-559
Abstract
The striation thickness distribution developed in an impingment T‐mixer is predicted using the statistical theory of turbulent diffusion. The predicted distribution is independent of the mixing nozzle Reynolds number, in agreement with some experiments, and is primarily a function of the mixing head geometry, the ratio of the reagent flow rates and the residence time distribution of the flow in the mixing head. Mixing is described as the result of fluid deformation in the intertial subrange of turbulent flow. The relationship of deformation to time and energy dissipation rate ϵ is examined. In the impingement T‐mixer ϵ is related to the kinetic energies of the streams entering and leaving the head. (There are no surface tension effects and pressure is relatively uniform in the mixing head, so that the kinetic energy is dissipated by viscous forces.) The distribution of residence times of fluid elements in the T‐mixer is responsible for varying degrees of deformation and hence a distribution of striation thickness. This residence time distribution does not seem to have been studied and the flow pattern was thus modeled as perfect macromixing, having an exponential distribution. The procedure developed in this paper to calculate the distribution of striation thickness allows reasonable estimates of its parameters from fluid mechanical information and showed good agreement with experimental values, without having to fit any quantities. This new approach to striation thickness distribution is worth further evaluation.Keywords
This publication has 4 references indexed in Scilit:
- The influence of impingement mixing on striation thickness distribution and properties in fast polyurethane polymerizationPolymer Engineering & Science, 1982
- Impingement mixing in reaction injection moldingPolymer Engineering & Science, 1980
- Mixing for reaction injection molding. I. Impingement mixing of liquidsPolymer Engineering & Science, 1980
- Mixing for reaction injection molding II. Impingement mixing of fiber suspensionsPolymer Engineering & Science, 1980