Thermal Characterization of New 3D-Printed Bendable, Coplanar Capacitive Sensors
Open Access
Abstract
In this paper a new low-cost stretchable coplanar capacitive sensor for liquid level sensing is presented. It has been 3D-printed by employing commercial thermoplastic polyurethane (TPU) and conductive materials and using a fused filament fabrication (FFF) process for monolithic fabrication. The sensor presents high linearity and good repeatability when measuring sunflower oil level. Experiments were performed to analyse the behaviour of the developed sensor when applying bending stimuli, in order to verify its flexibility, and a thermal characterization was performed in the temperature range from 10 °C to 40 °C to evaluate its effect on sunflower oil level measurement. The experimental results showed negligible sensitivity of the sensor to bending stimuli, whereas the thermal characterization produced a model describing the relationship between capacitance, temperature, and oil level, allowing temperature compensation in oil level measurement. The different temperature cycles allowed to quantify the main sources of uncertainty, and their effect on level measurement was evaluated.Keywords
This publication has 29 references indexed in Scilit:
- Additive manufacturing and characterization of a load cell with embedded strain gaugesPrecision Engineering, 2020
- Fused Filament Fabrication of Piezoresistive Carbon Nanotubes Nanocomposites for Strain MonitoringFrontiers in Materials, 2020
- Bidirectional and Stretchable Piezoresistive Sensors Enabled by Multimaterial 3D Printing of Carbon Nanotube/Thermoplastic Polyurethane NanocompositesPolymers, 2018
- Reliability and Maintenance Analysis of Unmanned Aerial VehiclesSensors, 2018
- Temperature-dependent electrical resistance of conductive polylactic acid filament for fused deposition modelingThe International Journal of Advanced Manufacturing Technology, 2018
- RBD Model-Based Approach for Reliability Assessment in Complex SystemsIEEE Systems Journal, 2018
- Electrically conductive filament for 3D-printed circuits and sensorsApplied Materials Today, 2017
- An inkjet-printed capacitive sensor for water level or quality monitoring: investigated theoretically and experimentallyJournal of Materials Chemistry A, 2017
- Temperature dependent electrical conductivity of CNT–PEEK compositesComposites Science and Technology, 2011
- A portable stray-immune capacitance meterReview of Scientific Instruments, 2002