Assessment of the Possibility of Using the Continuous Wavelet Transform and Fourier Transform to Analyse Geometric Structures Obtained on the Surface of Turned High-Molecular Polymers
Open Access
- 25 April 2025
- journal article
- Published by Jan Evangelista Purkyne University in Usti nad Labem in Manufacturing Technology
- Vol. 25 (1) , 24-36
Abstract
The article presents the possibilities of using wavelet transform and fast Fourier analysis (FFT) to evaluate the signal collected during roughness measurement. During the tests, high-density polyeth-ylene was turned using variable cutting par...Keywords
This publication has 29 references indexed in Scilit:
- Application of wavelet ratio between acoustic emission and cutting force signal decomposing in intelligent monitoring of cutting tool wear when turning SKD 61International Journal on Interactive Design and Manufacturing (IJIDeM), 2023
- Distinction between crack echoes and rebar echoes based on Morlet Wavelet Transform of impact echo signalsNDT & E International, 2019
- Surface quality monitoring in abrasive water jet machining of Ti6Al4V–CFRP stacks through wavelet packet analysis of acoustic emission signalsThe International Journal of Advanced Manufacturing Technology, 2019
- On the wavelet analysis of cutting forces for chatter identification in millingAdvances in Manufacturing, 2017
- Machining of tough polyethylene pipe material: surface roughness and cutting temperature optimizationThe International Journal of Advanced Manufacturing Technology, 2017
- Monitoring and processing signal applied in machining processes – A reviewMeasurement, 2014
- The optimal Mexican hat wavelet filter de-noising method based on cross-validation methodNeurocomputing, 2013
- Signal reconstruction, modeling and simulation of a vehicle full-scale crash test based on Morlet waveletsNeurocomputing, 2012
- Wavelet and fractal approach to surface roughness characterization after finish turning of different workpiece materialsJournal of Materials Processing Technology, 2009
- Application of the Discrete Wavelet Transform to the Monitoring of Tool Failure in End Milling Using the Spindle Motor CurrentThe International Journal of Advanced Manufacturing Technology, 1999