Ageing Behaviour of Al–Mg–Si Alloys After Cryogenic and Room Temperature Deformation
Open Access
Abstract
The aim of this study is to investigate the effects of cryogenic and room temperature pre-deformation on subsequent artificial ageing of Al–Mg–Si alloys. Naturally aged and pre-aged samples were strained to 5%, 10% and 20% at RT (25 °C) and under liquid nitrogen, and artificially aged at 185 °C. Pre-deformation generally increases ageing kinetics for both the naturally aged and pre-aged alloys, which increase in proportion to the degree of pre-deformation, and which are slightly more pronounced for the cryogenic condition. The peak strength is constant, except for when a low degree of pre-deformation is used, in which case it is slightly reduced. Cryogenically deformed samples show an increased strength and hardness, compared to samples pre-deformed at RT, when subjected to an equal magnitude of strain. This difference is reduced during artificial ageing. Synchrotron measurements reveal that this behaviour can be linked to the greater dislocation density, which is not completely recovered even after prolonged ageing at 185 °C.Keywords
Funding Information
- Österreichische Forschungsförderungsgesellschaft (853560)
- Christian Doppler Forschungsgesellschaft (Advanced Aluminum Alloys)
This publication has 33 references indexed in Scilit:
- Cryogenic Sheet Metal Forming - An OverviewMaterials Science Forum, 2018
- Mechanical properties and surface characteristics of an AA6060 alloy strained in tension at cryogenic and room temperatureMaterials Science and Engineering: A, 2015
- Aluminium Sheet Metal Forming at Low TemperaturesIOP Conference Series: Materials Science and Engineering, 2015
- Recent development in aluminium for automotive applicationsTransactions of Nonferrous Metals Society of China, 2014
- Effect of pre-ageing and natural ageing on the paint bake response of alloy AA6181AMaterials Science and Engineering: A, 2013
- Influence of natural aging on the precipitation hardening of an AlMgSi alloyMaterials Science and Engineering: A, 2010
- Pre-aging to improve bake hardening in a twin-roll cast Al–Mg–Si alloyMaterials Science and Engineering: A, 2005
- Recent development in aluminium alloys for the automotive industryMaterials Science and Engineering: A, 2000
- The suitability of aluminium as an alternative material for car bodiesMaterials & Design (1980-2015), 1999
- The effect of pre-aging on microstructure and tensile properties of Al-Mg-Si alloysScripta Materialia, 1997