Online monitoring and analysis of resin pressure inside composite laminate during zero‐bleeding autoclave process
Authors:
- 29 December 2010
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 32 (2) , 314-323
Abstract
Resin pressure is one of the most important parameters in manufacturing composites during autoclave process. It not only greatly influences resin flow behavior, but also has effects on void formation and elimination. Online monitoring resin pressure can provide an important guidance for the optimization of the processing parameters and the control of the quality of composites. In this study, a resin pressure online measuring system for autoclave process was established based on the principle of pressure transfer in liquid, and the size of the measuring probe of the system was optimized to increase the accuracy of measured resin pressure. The results indicate that the accuracy and the dynamic response of the system can meet the requirements of resin pressure measurement during autoclave process. Furthermore, by means of this proposed resin pressure measuring system and the measurements of compaction properties of the fabric stacks, the resin pressures inside carbon fiber fabric/epoxy resin and glass fiber fabric/epoxy resin prepreg stacks during autoclave process were investigated, especially for the zero‐bleeding process which is prevailing for aircraft composite structures. It is demonstrated that during zero‐bleeding process, the resin pressures, which conform to the spring and piston model, uniformly distribute along through‐thickness and in‐plane directions. In addition, the resin pressure profile is significantly influenced by the fiber volume fraction of the prepregs, indicating that fiber content of prepreg should be optimized for achieving free defects and uniform fiber distribution. POLYM. COMPOS., 2011. © 2010 Society of Plastics EngineersKeywords
This publication has 26 references indexed in Scilit:
- A simple method for the measurement of compaction and corresponding transverse permeability of composite prepregsPolymer Composites, 2007
- Numerical Simulation and Experimental Study on Consolidation of Toughened Epoxy Resin Composite LaminatesJournal of Composite Materials, 2006
- Multipurpose carbon fiber sensor design for analysis and monitoring of the resin transfer molding of polymer compositesPolymer Composites, 2005
- Measurement of the degree of cure of glass fiber–epoxy composites using dielectrometryJournal of Materials Processing Technology, 2001
- Assessment of flow and cure monitoring using direct current and alternating current sensing in vacuum-assisted resin transfer moldingSmart Materials and Structures, 2000
- Process monitoring of moulding compounds by ultrasonic measurements in a compression mouldNDT & E International, 2000
- Use of a simple, inexpensive pressure sensor to measure hydrostatic resin pressure during processing of composite laminatesPolymer Composites, 1999
- The 3-D Deformation Behavior of a Lubricated Fiber BundleJournal of Composite Materials, 1992
- The Consolidation of Laminate CompositesJournal of Composite Materials, 1987
- Curing of Epoxy Matrix CompositesJournal of Composite Materials, 1983