Speed of sound and isentropic bulk modulus of alkyl monoesters at elevated temperatures and pressures
- 1 December 2003
- journal article
- Published by Wiley in Journal of the American Oil Chemists' Society
- Vol. 80 (12) , 1249-1256
Abstract
Biodiesel is a biodegradable, sulfur‐free, oxygenated, and renewable alternative diesel fuel consisting of the alkyl monoesters of FA from vegetable oils and animal fats. Biodiesel can be used in existing diesel engines without significant modifications. However, differences in physical properties between biodiesel and petroleum‐based diesel fuel may change the engine's fuel injection timing and combustion characteristics. These altered physical and chemical properties also may cause the exhaust emissions and performance to differ from the optimized settings chosen by the engine manufacturer. In particular, the density, speed of sound, and isentropic bulk modulus have a significant effect on the fuel injection system and combustion. The objective of this study was to measure these three properties for biodiesel (and the pure esters that are the constituents of biodiesel) at temperatures from 20 to 100°C and at pressures from atmospheric to 32.5 MPa. Ten different biodiesel fuels, 16 different pure FA esters, three hydrocarbons, and one diesel fuel were tested. The measured values of density, speed of sound, and isentropic bulk modulus are presented. Correlations between pressure and temperature are demonstrated. Speed of sound and isentropic bulk modulus tend to increase as the degree of unsaturation increases and as the chain length increases. However, density increased with shorter chain length and decreased with saturation.Keywords
This publication has 17 references indexed in Scilit:
- The Effect of Timing and Oxidation on Emissions from Biodiesel-Fueled EnginesTransactions of the ASAE, 2001
- The speed of sound and isentropic bulk modulus of biodiesel at 21°C from atmospheric pressure to 35 MPaJournal of the American Oil Chemists' Society, 2000
- Ultrasonic analysis of edible fats and oilsUltrasonics, 1992
- Ultrasonic characterisation of emulsions and suspensionsAdvances in Colloid and Interface Science, 1991
- Ultrasonic velocity measurements in some liquid triglycerides and vegetable oilsJournal of the American Oil Chemists' Society, 1988
- Ultrasonics in food engineering. Part I: Introduction and experimental methodsJournal of Food Engineering, 1988
- Variation of Ultrasonic Velocity and Absorption with Temperature and Frequency in High Viscosity Vegetable OilsJapanese Journal of Applied Physics, 1971
- Experimental and Theoretical Study of Nitric Oxide Formation in Internal Combustion EnginesCombustion Science and Technology, 1970
- Physical Properties of Triglycerides III: Ultrasonic Sound VelocityFette, Seifen, Anstrichmittel, 1967
- The Adiabatic Bulk Modulus of Normal Paraffin Hydrocarbons From Hexane to HexadecaneJournal of Basic Engineering, 1960