Dispersion Analysis and Design of Planar Electromagnetic Bandgap Ground Plane for Broadband Common-Mode Suppression
Authors:
- 13 February 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 24 (11) , 772-774
Abstract
A planar electromagnetic bandgap (EBG) structure designed for broadband common-mode suppression is proposed. A uniplanar compact photonic-bandgap (UC-PBG) structure with periodic center slots is etched on the ground plane to obtain broadband common mode suppression while minimally disturbing the differential signal within the designed bandwidth. Dispersion analysis has been conducted for both common (even) and differential (odd) mode signals. Good signal integrity is observed in both simulated and measured results. The fractional bandwidth of the proposed EBG ground plane is around 70% with common-mode suppression below -20 dB. The proposed EBG ground planes may be applicable for systems requiring low-cost and simple solutions in designing high-speed differential interlinks operating above 5 Gbps.Keywords
This publication has 10 references indexed in Scilit:
- Common-Mode Suppression in Microstrip Differential Lines by Means of Complementary Split Ring Resonators: Theory and ApplicationsIEEE Transactions on Microwave Theory and Techniques, 2012
- A Broadband and Miniaturized Common-Mode Filter for Gigahertz Differential Signals Based on Negative-Permittivity MetamaterialsIEEE Transactions on Microwave Theory and Techniques, 2009
- A Novel Wideband Common-Mode Suppression Filter for Gigahertz Differential Signals Using Coupled Patterned Ground StructureIEEE Transactions on Microwave Theory and Techniques, 2009
- An Embedded Common-Mode Suppression Filter for GHz Differential Signals Using Periodic Defected Ground PlaneIEEE Microwave and Wireless Components Letters, 2008
- In-Circuit Characterization of Common-Mode ChokesIEEE Transactions on Electromagnetic Compatibility, 2007
- Stopband Analysis Using Dispersion Diagram for Two-Dimensional Electromagnetic Bandgap Structures in Printed Circuit BoardsIEEE Microwave and Wireless Components Letters, 2006
- A new wideband common-mode noise filter consisting of Mn-Zn ferrite core and copper/polyimide tape wound coilIEEE Transactions on Magnetics, 2005
- Metallo-dielectric electromagnetic bandgap structures for suppression and isolation of the parallel-plate noise in high-speed circuitsIEEE Transactions on Microwave Theory and Techniques, 2003
- A novel power plane with integrated simultaneous switching noise mitigation capability using high impedance surfaceIEEE Microwave and Wireless Components Letters, 2003
- A uniplanar compact photonic-bandgap (UC-PBG) structure and its applications for microwave circuitIEEE Transactions on Microwave Theory and Techniques, 1999