Investigating the Effect of Particle Sizes of SiC and Graphite on Strengthening of Aluminium Metal Matrix Composites
Authors:
- 1 February 2024
- journal article
- research article
- Published by The Electrochemical Society in ECS Journal of Solid State Science and Technology
- Vol. 13 (2) , 021002
Abstract
The endeavour of this research work is to scrutinize the effect of reinforcement materials: Silicon Carbide (SiC) and Graphite (Gr) on the mechanical properties of Al-Mg-Si alloy (AA6061). Sample of composites were fabricated using the stir casting technique, incorporating four weight (wt.) ratio of individual reinforcement and two different sizes of the particles. SiC, a resilient ceramic and graphite were chosen as reinforcements to estimate their shared impact on the mechanical characteristics of the composite. Hybrid Metal Matrix Composite (HMMCs) were created with varying weight percentage of 4%; 3%; 2%; 1% for the above selected reinforcements separately with two combinations of the particle dimensions: System-I (SiC-25 μm and Graphite-75 μm) and System-II (SiC-5 μm and Graphite-25 μm). Mechanical characterization of composite samples including hardness, wear rate, compressive strength, was analyzed for both System-I and System-II. Scanning Electron Microscope (SEM) was employed for microstructure analysis, X-ray diffraction (XRD) for phase identifications. Mechanical characterization revealed both System-I & II with uniform dispersion of reinforcement particles. System-I exhibited higher density and lower wear resistance compared to System-II under all load conditions.Keywords
This publication has 44 references indexed in Scilit:
- Effect of Ceramic Reinforcement on Physical and Mechanical Behaviour of AL6061 Metal Matrix Composites Fabricated Using Stir Casting TechniqueInternational Journal of Metalcasting, 2022
- Fabrication and Characterization of Hybrid Aluminium (Al6061) Metal Matrix Composite Reinforced with SiC, B4C and MoS2 via Stir CastingInternational Journal of Metalcasting, 2022
- Study of pore morphology, microstructure, and cell adhesion behaviour in porous Ti-6Al-4V scaffoldsEmergent Materials, 2019
- Microstructure and tribological behavior of interfaces in Cu-SiO2 and Cu-Cr metal matrix compositesJournal of Alloys and Compounds, 2019
- Effect of thermal processing on the tribology of nanocrystalline Ni/TiO2 coatingsEmergent Materials, 2018
- Recent advances in electroless-plated Ni-P and its composites for erosion and corrosion applications: a reviewEmergent Materials, 2018
- Study of Processing and Microstructure of Copper Composite Reinforced with Graphene Nanosheet by Powder Metallurgy TechniquePowder Metallurgy and Metal Ceramics, 2018
- Microstructural and mechanical properties of Al-4.5wt% Cu reinforced with alumina nanoparticles by stir casting methodInternational Journal of Minerals, Metallurgy and Materials, 2013
- The fibre/matrix interface and its influence on mechanical and physical properties of Cu-MMCComposites Science and Technology, 2010
- Metal matrix composites – From science to technological significanceComposites Science and Technology, 2005