Reliability of 4H-SiC SBD/JBS diodes under repetitive surge current stress
Authors:
- 1 September 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 23293721,p. 2245-2248
Abstract
The reliability of power diode under surge current stress is crucial to the applications like motor drives. In this paper, the single and repetitive surge reliability of the 4H-SiC Schottky Barrier Diodes (SBDs) and Junction Barrier Schottky (JBS) diodes have been tested and the corresponding failure mechanisms studied. The single surge test results of two SBDs and three JBS didoes suggest a 450W/mm2 constant power line of the safe operation area for single surge current with a half sinusoidal pulse width of 8.3ms. The stress tests show no degradation of SBDs up to 10,000 cycles of surge current below 34.9A/mm2. The JBS diodes show VF degradation after surge stress at different current levels, which might be dependent on the hole injection levels. The aluminum metallization and bipolar degradation are the main limits for the reliability of SiC diodes under surge conditions.Keywords
This publication has 12 references indexed in Scilit:
- Thermal Stability of Silicon Carbide Power DiodesIEEE Transactions on Electron Devices, 2012
- Reliability of aluminum-bearing ohmic contacts to SiC under high current densityMicroelectronics Reliability, 2010
- Recombination-induced stacking fault degradation of 4H-SiC merged-PiN-Schottky diodesJournal of Applied Physics, 2009
- Optimization of on-State and Switching Performances for 15–20-kV 4H-SiC IGBTsIEEE Transactions on Electron Devices, 2008
- A New Degradation Mechanism in High-Voltage SiC Power MOSFETsIEEE Electron Device Letters, 2007
- 2nd Generation 600V SiC Schottky Diodes Use Merged pn/Schottky Structure for Surge Overload Protection2006
- Carrier mobility model for simulation of SiC-based electronic devicesSemiconductor Science and Technology, 2002
- Electron mobility models for 4H, 6H, and 3C SiC [MESFETs]IEEE Transactions on Electron Devices, 2001
- Electrothermal Simulation of 4H-SiC Power DevicesMaterials Science Forum, 1998
- Electromigration failure modes in aluminum metallization for semiconductor devicesProceedings of the IEEE, 1969