A Power Efficiency Improvement Technique for a Bidirectional Dual Active Bridge DC–DC Converter at Light Load
Authors:
- 30 May 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industry Applications
- Vol. 50 (6) , 4047-4055
Abstract
Bidirectional dc-dc converters, which make possible the bidirectional transmission of power, have become indispensable in recent years due to the diversification of the power supply network, including the use of batteries. Of these, the dual active bridge (DAB) dc-dc converter features a simple mechanism and symmetric circuit architecture, making possible the equal transmission of power in both directions. Because of these advantageous characteristics, DAB dc-dc converters are in wide use. However, this circuit has the intrinsic problems that, during light-load conditions, switching surges occur and power efficiency decreases. This paper proposes digitally controlled operation as a new method to resolve these problems and reports on an experiment that was carried out using a 1-kW system. In addition, for both buck and boost modes, output power characteristic equations were derived through application of the extended state-space averaging method, and a loss-included circuit analysis was carried out for the circuit used in the experiment. It was thereby demonstrated that circuit loss was smaller for the proposed operation than that for conventional operation. In the loss-included circuit analysis, for both proposed and conventional operations, equivalent circuits that approximated circuit loss as a single resistance were used. As a result, it was confirmed that, with the operation proposed in this paper, without the use of a snubber circuit, switching surges could be reduced significantly and also that, during light load, there was a power efficiency improvement of up to 16%. In addition, a loss-included circuit analysis with a single equivalent resistance has been done. The resistance value is assigned with the averaged circuit total resistance. By the analysis, a relation between phase difference and output power is obtained. The results were confirmed with the experiment.Keywords
This publication has 16 references indexed in Scilit:
- A static characteristic analysis of proposed bi-directional dual active bridge DC-DC converter2014
- Switching surge reduction of a bi-directional dual active bridge DC-DC converter with a digital operation2013
- Closed Form Solution for Minimum Conduction Loss Modulation of DAB ConvertersIEEE Transactions on Power Electronics, 2012
- An ac-link bidirectional DC-DC converter with synchronous rectifier2010
- Accurate Small-Signal Model for the Digital Control of an Automotive Bidirectional Dual Active BridgeIEEE Transactions on Power Electronics, 2009
- Switching Control Strategy to Minimize Dual Active Bridge Converter LossesIEEE Transactions on Power Electronics, 2009
- Hybrid Modulation for Dual-Active-Bridge Bidirectional Converter With Extended Power Range for Ultracapacitor ApplicationIEEE Transactions on Industry Applications, 2009
- A bidirectional DC–DC converter for fuel cell electric vehicle driving systemIEEE Transactions on Power Electronics, 2006
- A unified analysis of resonant convertersIEEE Transactions on Power Electronics, 1991
- A three-phase soft-switched high-power-density DC/DC converter for high-power applicationsIEEE Transactions on Industry Applications, 1991