Microstructure evolution of directionally solidified Nb–Si alloy
Authors:
- 1 April 2014
- journal article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 30 (4) , 418-423
Abstract
By taking the method of liquid–metal cooled directional solidification, alloys with a nominal composition of Nb–14Si–24Ti–10Cr–2Al–2Hf (at-) were prepared under different conditions. Alloys were initially directional solidified with different withdrawal rates ( R = 1·2, 6, 18 mm min−1) at 1750°C and subsequently heat treated at 1450°C for 10 h. These processes aimed to investigate the microstructure of directionally solidified (DS) and heat treated (HT) alloys by XRD, SEM, and EDS. The microstructure of DS alloy was composed of (Nb,Ti)SS, (Nb,Ti)5Si3, and Laves phase Cr2Nb, and the former two components formed (Nb,Ti)SS+(Nb,Ti)5Si3 eutectics. In addition, (Nb,Ti)5Si3 laths only presented in DS1·2 alloy. With the increasing withdrawal rates, the microstructure of alloy altered from hypereutectic into pseudo-eutectic, accompanied with the eutectic morphology transformation from petaloid into coupled. Also, the dimension of constituent phases reduced. However, after heat treatment, the constituent phases did not change. The petaloid morphology of eutectics in DS specimens disappeared and coupled eutectic transferred into network. The block or needle-like Cr2Nb gathered along the boundary between (Nb,Ti)5Si3 and (Nb,Ti)SS, and the overall alloy composition became homogenisation.Keywords
This publication has 15 references indexed in Scilit:
- The Hotter the Engine, the BetterScience, 2009
- A review of very-high-temperature Nb-silicide-based compositesMetallurgical and Materials Transactions A, 2003
- Niobium Silicide High Temperature In Situ Composites2002
- Processing high-temperature refractory-metal silicide in-situ compositesJOM, 1999
- Gradient protective coatings of different application produced by EB-PVDSurface and Coatings Technology, 1998
- Refractory metal-intermetallic in-situ composites for aircraft enginesJOM, 1997
- The balance of mechanical and environmental properties of a multielement niobium-niobium silicide-basedIn Situ compositeMetallurgical and Materials Transactions A, 1996
- High-temperature refractory metal-intermetallic compositesJOM, 1996
- The development of Nb-based advanced intermetallic alloys for structural applicationsJOM, 1996
- Deformation and fracture behavior of Nb in Nb5Si3/Nb laminates and its effect on laminate toughnessActa Metallurgica et Materialia, 1995