Assessment of the Axial Load Response of an H Pile Driven in Multilayered Soil
- 1 December 2009
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 135 (12) , 1789-1804
Abstract
Most of the current design methods for driven piles were developed for closed-ended pipe piles driven in either pure clay or clean sand. These methods are sometimes used for H piles as well, even though the axial load response of H piles is different from that of pipe piles. Furthermore, in reality, soil profiles often consist of multiple layers of soils that may contain sand, clay, silt or a mixture of these three particle sizes. Therefore, accurate prediction of the ultimate bearing capacity of H piles driven in a mixed soil is very challenging. In addition, although results of well documented load tests on pipe piles are available, the literature contains limited information on the design of H piles. Most of the current design methods for driven piles do not provide specific recommendations for H piles. In order to evaluate the static load response of an H pile, fully instrumented axial load tests were performed on an H pile ( HP 310×110 ) driven into a multilayered soil profile consisting of soils com...Keywords
This publication has 27 references indexed in Scilit:
- Pile and penetrometer end bearing resistance in two-layered soil profilesGéotechnique, 2008
- Behaviour of jacked and driven piles in sandy soilGéotechnique, 2006
- Static loading test on a 45 m long pipe pile in Sandpoint, IdahoCanadian Geotechnical Journal, 2004
- Evaluation of a Minimum Base Resistance for Driven Pipe Piles in Siliceous SandJournal of Geotechnical and Geoenvironmental Engineering, 2002
- A×ial compressive capacity of driven piles in sand: a method including post-driving residual stressesCanadian Geotechnical Journal, 2001
- Estimation of Post-Driving Residual Stresses Along Driven Piles in SandGeotechnical Testing Journal, 2000
- Evaluation of Pile Capacity Prediction Methods Based on Cone Penetration Testing Using Results from I-15 Load TestsTransportation Research Record: Journal of the Transportation Research Board, 1999
- Prediction of Bearing Capacity of Friction Piles in Soft Louisiana Soils by Cone Penetration TestTransportation Research Record: Journal of the Transportation Research Board, 1999
- Axial load transfer for piles in sand. II. Numerical analysisCanadian Geotechnical Journal, 1992
- Load Tests Results on Friction Piles in SandCanadian Geotechnical Journal, 1971