Process Parameters and Residual Stresses in Cylindrical Grinding
- 11 July 2002
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 124 (3) , 615-623
Abstract
The paper presents an experimental study on the relationship between process parameters and residual stresses in cylindrical grinding. In particular, the influence of the depth of cut (a) and the peripheral velocity of the workpiece vw was investigated. Residual stresses were found to depend on both parameters, but the effect of the peripherial velocity depends on the grinding conditions. In “easy to grind” conditions an increase in workpiece velocity leads to an increase in residual stresses, but in “difficult to grind” conditions an increase in workpiece velocity results in a decrease in residual stresses. Consequently, two joint parameters, Zw=as˙vw, and Kw=a/vw, were used to predict residual stresses. Regression analysis was then performed to determine the analytic relationship between the joint parameters and the residual stresses in “easy” and “difficult” grinding conditions. Finally, the influence of wheel wear, feed rate, sparkout and wheel dressing was investigated. The study showed that the workpiece feed rate does not seem to influence the residual stresses, while sparkout, wheel wear, and wheel dressing significantly affect the level of residual stresses generated during machining.Keywords
This publication has 11 references indexed in Scilit:
- Applied mechanics in grinding—V. Thermal residual stressesInternational Journal of Machine Tools and Manufacture, 1997
- An Attempt to Predict Residual Stresses in Grinding of Metals with the Aid of a New Grinding ParameterCIRP Annals, 1991
- An Improved Mathematical Model to Predict Residual Stresses in Surface Plunge GrindingCIRP Annals, 1987
- Contribution of CIRP Research to Industrial Problem in GrindingCIRP Annals, 1984
- Important Results on External Cylindrical Plunge Grinding with Unusual Workpiece Peripheral Speeds and Speed Ratios q in the Range of -0.2 to -20 000CIRP Annals, 1983
- The Surface Roughness Produced when Austenitic Stainless Steel is Ground by Alumina WheelsCIRP Annals, 1982
- Prevision of Thermal Residual Stresses in Surface Plunge Grinding of SteelsCIRP Annals, 1982
- Evolution of Residual Stress During Turning and Cylindrical Grinding of a Carbon SteelCIRP Annals, 1982
- Residual Stresses — Measurement and Causes in Machining ProcessesCIRP Annals, 1982
- The Factors Influencing the Surface Finish Produced by Grinding1974