Experimental Investigation of Silicon-Based Micro-Pulsating Heat Pipe for Cooling Electronics
Authors:
- 1 January 2012
- journal article
- research article
- Published by Taylor & Francis in Nanoscale and Microscale Thermophysical Engineering
- Vol. 16 (1) , 37-49
Abstract
A simultaneous temperature measurement and flow visualization experiment was performed to investigate the thermal and flow behaviors of a silicon-based micro-pulsating heat pipe (micro-PHP) with trapezoidal microchannels with a hydraulic diameter of 352 μm. FC-72 and R113 were used as working fluids. Variations in temperature versus time at different locations of the micro-PHP under different power inputs and typical flow patterns in microchannels were recorded. The evaporator wall temperature, or the maximum localized temperature, of the micro-PHP at moderate filling ratios was measured and compared to those derived from the empty microdevice (0% filling ratio). Experimental results showed that a micro-PHP embedded in a semiconductor chip could significantly decrease the maximum localized temperature. At a power input of 6.3 W, reductions in the evaporator wall temperature of about 42.1°C (or 34.1%) and 41.9°C (or 33.9%) were obtained for the micro-PHP charged with R113 at filling ratios of 41 and 58%, respectively. When the micro-PHP charged with FC-72, a maximum power input of about 9.5 W associated with a heat flux up to 10.7 W/cm2 was reached at a moderate rise in wall temperature of the evaporator. The visualization study demonstrated that the evaporation, adiabatic, and condensation sections of the micro-PHP were largely occupied by annular, slug, and slug–bubbly flows, respectively, at a steady state characterized by sustained self-exciting oscillations of working fluid. However, no local nucleate boiling was detected in the micro-PHP at the power input range, which was different from the results reported for traditional PHPs.Keywords
This publication has 21 references indexed in Scilit:
- Fabrication of polydimethylsiloxane (PDMS) pulsating heat pipeApplied Thermal Engineering, 2009
- Uniform Mems Chip Temperatures in the Nucleate Boiling Heat Transfer Region by Selecting Suitable, Medium Boiling Number RangeNanoscale and Microscale Thermophysical Engineering, 2007
- A capillary-pumped loop (CPL) with microcone-shaped capillary structure for cooling electronic devicesJournal of Micromechanics and Microengineering, 2007
- Theoretical analysis of startup of a pulsating heat pipeInternational Journal of Heat and Mass Transfer, 2007
- High speed flow visualization of a closed loop pulsating heat pipeInternational Journal of Heat and Mass Transfer, 2005
- Heat pipes in modern heat exchangersApplied Thermal Engineering, 2005
- Fabrication and experimental investigation of silicon micro heat pipes for cooling electronicsJournal of Micromechanics and Microengineering, 2003
- THERMOFLUID DYNAMIC STUDY OF FLAT-PLATE CLOSED-LOOP PULSATING HEAT PIPESMicroscale Thermophysical Engineering, 2003
- Fabrication and test of radial grooved micro heat pipesApplied Thermal Engineering, 2002
- Enhanced Boiling of FC-72 on Silicon Chips With Micro-Pin-Fins and Submicron-Scale RoughnessJournal of Heat Transfer, 2001