TG-MS Analysis of the Effect of Variations in Coal Particle Size on Combustion Characteristics and Kinetic Parameters
Open Access
Abstract
This study investigated the influence of particle size on combustion performance using equivalent characteristic spectrum analysis (ECSA) on a TG-MS platform. The experiments were conducted at heating rates of 10 °C/min and 20 °C/min for three granular coal types with particle sizes of 1 mm, 4 mm, and 8 mm. The results showed that the ignition temperature, burnout temperature, and burnout time generally increased with particle size, while the combustion characteristic index for the 8 mm particles was 28.81% lower than that for 1 mm particles. The particle size effects were more pronounced at lower heating rates. Combustion kinetics revealed that the pre-combustion endothermic stage had a significant impact on the ignition temperature, followed by the volatilization stage. For Shenmu bituminous coal (SBC), a 1 kJ/mol reduction in apparent activation energy during the endothermic stage increased the ignition temperature by 13.02 °C (10 °C/min) or 17.11 °C (20 °C/min). Similar trends were observed for Datong bituminous coal (DBC) and Jincheng anthracite coal (JAC). A gas product analysis indicated that the peak release temperatures rose with particle size, and particle size variations affected the maximum release rates and combustion stage duration. Smaller particles generally released less NO during combustion.Keywords
Funding Information
- “Key technology and demonstration of deep and flexible peaking for circulating fluidized bed boiler” project, Strategic Priority Research Program of the Chinese Academy of Sciences (XDA29010100)
This publication has 38 references indexed in Scilit:
- Effects of particle size and oil-immersed concentration on the dust layer minimum ignition temperature and combustion characteristics of oil-immersed coalJournal of Thermal Analysis and Calorimetry, 2024
- Combustion and NOx Emission Characteristics of Coal Slime Solid Waste at Different Feeding PositionsJournal of Thermal Science, 2023
- Experimental Study on the Effect of Bed Material Amount and Fuel Particle Size on Load Change of Circulating Fluidized BedJournal of Thermal Science, 2023
- Effects of the Secondary Air Excess Ratio on the Self-Preheating Combustion Characteristics and NOx Emission of Semi-CokeJournal of Thermal Science, 2023
- Experiment Study on the High-Temperature Thermal Treatment and Ultra-Low NOx Control of Solid Waste Coal Slime in Circulating Fluidized BedJournal of Thermal Science, 2022
- Preheating Combustion Characteristics of Ultra-Low Volatile Carbon-Based FuelJournal of Thermal Science, 2019
- Pressurized oxy-fuel combustion performance of pulverized coal for CO 2 captureApplied Thermal Engineering, 2016
- Thermal–hydraulic calculation and analysis of a 600 MW supercritical circulating fluidized bed boiler with annular furnaceApplied Thermal Engineering, 2016
- Ignition Delay Time − an Important Fuel PropertyChemistry and Technology of Fuels and Oils, 2016
- Oxy-fired fluidized bed combustors with a flexible power output using circulating solids for thermal energy storageApplied Energy, 2014