Experimental analysis of microhardness changes of subsurface areas affected by WEDM
- 10 February 2022
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering
- Vol. 236 (5) , 1979-1991
Abstract
The influence of the surface area by the impact of high temperatures after wire electric discharge machining (WEDM) is a known fact. However, the affected parameters also include a change in microhardness. In order to further investigate this statement, 5 different ferrous and non-ferrous materials were selected, from which three samples were always made with different settings of machine parameters (gap voltage, pulse on and off time, wire feed and discharge current). This examined not only the effect of the machining itself on the material but also whether the change in the microhardness of the material is affected by the setting of the machine parameters. In order to measure the microhardness of the subsurface layer, a metallographic preparation was made from each sample, which enabled accurate measurements always in the same area. Subsequent evaluation revealed that the microhardness may not be affected at all and everything depends only on the type of material being machined. The changes in microhardness affected by setting machine parameters are negligible.Keywords
All Related Versions
Funding Information
- Vysoké Učení Technické v Brně (FSI-S-17-4464, LM2018110)
- Univerzite Jan Evangelista Purkyne v Ústí nad Labem (CZ.02.1.01/0.0/0.0/18_069/0010045)
This publication has 20 references indexed in Scilit:
- Properties Evaluation of Thin Microhardened Surface Layer of Tool Steel after Wire EDMMetals, 2016
- WEDM of nickel based aerospace alloy: optimization of process parameters and modellingInternational Journal on Interactive Design and Manufacturing (IJIDeM), 2016
- Structure and Composition of the White Layer in the Wire-EDM ProcessProcedia CIRP, 2016
- Effect of Wire EDM Cutting Parameters for Evaluating of Additive Manufacturing Hybrid Metal MaterialProcedia Manufacturing, 2015
- EBSD-Analysis of Flexure Hinges Surface Integrity Evolution via Wire-EDM Main and Trim Cut TechnologiesProcedia CIRP, 2014
- Surface Integrity Characteristics in Wire-EDM of Inconel 718 at Different Discharge EnergyProcedia CIRP, 2013
- Investigation of the effect of process parameters on the formation and characteristics of recast layer in wire-EDM of Inconel 718Materials Science and Engineering: A, 2009
- Workpiece surface roughness and integrity after WEDM of Ti–6Al–4V and Inconel 718 using minimum damage generator technologyCIRP Annals, 2008
- The wire electro-discharge machining characteristics of Fe–30Mn–6Si and Fe–30Mn–6Si–5Cr shape memory alloysJournal of Materials Processing Technology, 2005
- State of the art in wire electrical discharge machining (WEDM)International Journal of Machine Tools and Manufacture, 2004