A 5 mm$^{2}$ 40 nm LP CMOS Transceiver for a Software-Defined Radio Platform
- 14 October 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 45 (12) , 2794-2806
Abstract
A 5 mm2 transceiver front-end suitable for a software-defined radio (SDR) platform is implemented in a 40-nm LP digital CMOS technology. Tailored for all modern communication standards relevant for a modern handheld mobile device (2G/3G/4G cellular, WLAN, Bluetooth, GPS, broadcasting, etc.), it uses radio architectures and circuits that ensure flexible performance at a minimal cost in area and power consumption. The receive section features four parallel LNAs to cover the frequency range from 100 MHz up to 6 GHz, a 25 % duty cycle passive mixer with IIP2 calibration, fifth-order baseband filtering up to 20 MHz, variable-gain amplification, and a 10-b 65 MS/s 34 fj/conv-step SAR ADC. It achieves NF down to 2.4 dB, more than 30-dB EVM and 50-dBm IIP2. In the transmit section, main emphasis is given to the out-of-band noise requirement that enables SAW-less operation in FDD systems: a flexible reconstruction filter is followed by a voltage-sampling mixer and a variable gain PPA. The TX chain achieves 3.2% EVM at 0-dBm output power, with CNR down to-156 dBc/Hz. For frequency synthesis, two dual-VCO 5.9-12.8 GHz fractional-N PLLs are implemented together with a chain of divide-by-2 circuits for quadrature generation.Keywords
This publication has 20 references indexed in Scilit:
- A tri-band SAW-less WCDMA/HSPA RF CMOS transceiver with on-chip DC-DC converter connectable to battery2010
- A 2-mm$^{2}$ 0.1–5 GHz Software-Defined Radio Receiver in 45-nm Digital CMOSIEEE Journal of Solid-State Circuits, 2009
- A Low-Power, Low-EVM, SAW-Less WCDMA Transmitter Using Direct Quadrature Voltage ModulationIEEE Journal of Solid-State Circuits, 2009
- Calibration of Direct-Conversion TransceiversIEEE Journal of Selected Topics in Signal Processing, 2009
- Single-chip multiband WCDMA/HSDPA/HSUPA/EGPRS transceiver with diversity receiver and 3G DigRF interface without SAW filters in transmitter / 3G receiver paths2009
- Low-Area Active-Feedback Low-Noise Amplifier Design in Scaled Digital CMOSIEEE Journal of Solid-State Circuits, 2008
- A low-noise self-calibrating dynamic comparator for high-speed ADCs2008
- A 65 nm CMOS Multistandard, Multiband TV Tuner for Mobile and Multimedia ApplicationsIEEE Journal of Solid-State Circuits, 2008
- Flexible Baseband Analog Circuits for Software-Defined Radio Front-EndsIEEE Journal of Solid-State Circuits, 2007
- The First Fully Integrated Quad-Band GSM/GPRS Receiver in a 90-nm Digital CMOS ProcessIEEE Journal of Solid-State Circuits, 2006