Optimization of Reciprocating Friction and Wear Test Rig Operating Parameters for Segmented Piston Ring: Liner Assembly
Authors:
- 17 October 2013
- book chapter
- Published by Springer Nature
- p. 205-214
Abstract
No abstract availableKeywords
This publication has 13 references indexed in Scilit:
- The potential of plasma electrolytic oxidized eutectic aluminium-silicon alloy as a cylinder wall surface for lightweight engine blocksProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2009
- Friction and Wear of Low-Phosphorus Engine Oils with Additional Molybdenum and Boron Compounds, Measured on a Reciprocating Lubricant TesterTribology Transactions, 2008
- Engine Oil Effects on Friction and Wear Using 2.2L Direct Injection Diesel Engine Components for Bench Testing Part 2: Tribology Bench Test Results and Surface AnalysesSAE International Journal of Advances and Current Practices in Mobility, 2004
- Piston Ring-Cylinder Bore Friction Modeling in Mixed Lubrication Regime: Part II—Correlation With Bench Test DataJournal of Tribology, 1999
- Piston Ring-Cylinder Bore Friction Modeling in Mixed Lubrication Regime: Part I—Analytical ResultsJournal of Tribology, 1999
- Surface and Engine Oil Effects on Journal Bearing LubricationSAE International Journal of Advances and Current Practices in Mobility, 1998
- Development of a Reciprocating Test Rig for Tribological Studies of Piston Engine Moving Components - Part I: Rig Design and Piston Ring Friction Coefficients Measuring MethodSAE International Journal of Advances and Current Practices in Mobility, 1993
- Tribological properties of titanium alloysWear, 1991
- An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic LubricationJournal of Lubrication Technology, 1978
- The Contact of Two Nominally Flat Rough SurfacesProceedings of the Institution of Mechanical Engineers, 1970