On the Stretch-Flangeability of High Mn TWIP Steels
Authors:
- 30 June 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 654-656, 278-281
Abstract
Edge stretching is an important formability issue when it comes to apply sheet steels to automotive industry. Anisotropy, strain hardening and toughness are closely related to hole expansion properties. In this paper, hole expansion properties of a high Mn fully austenitic Twinning Induced Plasticity (TWIP) steel are compared with three other types of single-phase sheet steels. The effects of r-value, n-value, m-value and post-uniform elongation on the edge stretch-flangeability are discussed. It was found that the post-uniform elongation and the strain rate sensitivity have a pronounced effect on hole expansion properties.Keywords
This publication has 5 references indexed in Scilit:
- Spatio-temporal characteristics of the Portevin–Le Châtelier effect in austenitic steel with twinning induced plasticityInternational Journal of Plasticity, 2009
- Stretch-flangeability characterisation of multiphase steel using a microstructure based failure modellingComputational Materials Science, 2009
- Failure During Sheared Edge StretchingJournal of Materials Engineering and Performance, 2008
- Hole Expansion in a Variety of Sheet SteelsJournal of Materials Engineering and Performance, 2006
- The relationships between tensile properties and hole expansion property of C-Mn steelsJournal of Materials Science, 2003