On Residual Stress Induced Distortions during Fabrication of Composite Shells
Authors:
- 1 August 1996
- journal article
- research article
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 15 (8) , 793-805
Abstract
Channel or angle components are important structural members. It has been observed that during the manufacture of these components, residual stresses build up. The state of residual stress in these components leads to a reduction in the enclosed angle where the out-of-plane contraction is higher than the in-plane contraction. This phenomenon (of the reduction in the enclosed angle) is referred to as spring-in. The residual stresses, in addition, may lead to defects such as micro-cracking, delamination, etc. The degree of spring-in and the residual stresses may be estimated by analysing the curved portions of these structural components as sectors of circular cylindrical tubes (see Figure 1). In this paper, a simple mechanics-based model is developed using modified shell theory that predicts the degree of spring-in and determines the stresses and strains in cylindrical segments with arbitrary lay-ups subjected to random temperature gradients. The model accounts for the resin shrinkage occurring during curing and also includes the effect of moisture gradients. The accuracy of the present analysis is investigated by comparing predicted results with previously published results.Keywords
This publication has 4 references indexed in Scilit:
- Approximate Analysis of the Temperature Induced Stresses and Deformations of Composite ShellsJournal of Composite Materials, 1994
- Response of thick laminated composite rings to thermal stressesComposite Structures, 1991
- Design and fabrication of composite components; the spring-forward phenomenonComposites, 1989
- Matrix solidification and the resulting residual thermal stresses in compositesJournal of Materials Science, 1985