Channel Modeling and Over-the-Air Signal Quality at 3.5 GHz for 5G New Radio
Open Access
- 13 January 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 9, 11183-11193
Abstract
With the next generation of mobile communication being trialled across the world, 5G New Radio (NR) promises to provide a flexible radio interface that fits a diverse range of use cases. As trials and pilots progress, propagation studies are required that evaluate electromagnetic (EM) propagation effects for 5G NR signals. In this article, 5G NR signals are used to evaluate the over-the-air (OTA) error vector magnitude (EVM) within a line-of-sight (LoS) rural/urban environment. For the same receiver locations, time dispersion and propagation loss were measured via the root mean square (RMS) delay spread and path loss. The transmitter-receiver distance investigated ranged from 60 m to 450 m. From the measurement campaign, the path loss exponent (PLE) using a directional antenna at the receiver was 1.98, and 1.82 with an omnidirectional antenna. The root mean square error (RMSE) of the floating intercept/close-in (FI/CI) models for the path loss was 4.96/4.74 and 3.84/3.23 for directional and omnidirectional receivers. The delay spread using a cross polar configuration showed significant increase and a dependency of the delay spread on the path loss was observed. For the measurement route, the mean delay spread was 24 ns and 35 ns for directional and omnidirectional measurements. With regards to the EVM, 16 and 64-QAM transmissions were robust along the entire route for directional and omnidirectional antennas, whereas 256-QAM worked in locations where there was minimal obstruction to the propagation path. The average EVM (%) for 16, 64 and 256-QAM measured along the route was 4.5/5.3/3.9 and 3.4/4.3/3.6 for omnidirectional and directional antennas. The OTA results also show that using a directional antenna (as the receiver) significantly improves the obtainable signal quality of 5G NR signals and also reduces outages for higher modulation schemes. With the measurement results presented, system designers can design efficient receivers, estimate coverage and adequately provision services using 5G NR on the sub-6 GHz frequency band.Keywords
Funding Information
- Innovate UK via Midlands Future Mobility (MFM) as part of the UK CAM testing facility
This publication has 28 references indexed in Scilit:
- Rural Macrocell Path Loss Models for Millimeter Wave Wireless CommunicationsIEEE Journal on Selected Areas in Communications, 2017
- Channel measurements and modeling for 5G communication systems at 3.5 GHz band2016
- Channel estimation in rotating polarization based wireless communication systems2016
- Indoor Office Wideband Millimeter-Wave Propagation Measurements and Channel Models at 28 and 73 GHz for Ultra-Dense 5G Wireless NetworksIEEE Access, 2015
- Wideband Millimeter-Wave Propagation Measurements and Channel Models for Future Wireless Communication System DesignIEEE Transactions on Communications, 2015
- Joint User Node Positioning and Clock Offset Estimation in 5G Ultra-Dense Networks2014
- The role of small cells, coordinated multipoint, and massive MIMO in 5GIEEE Communications Magazine, 2014
- Localization Algorithm with On-line Path Loss Estimation and Node SelectionSensors, 2011
- Path loss, delay spread, and outage models as functions of antenna height for microcellular system designIEEE Transactions on Vehicular Technology, 1994
- Phase shift pulse codes with good periodic correlation properties (Corresp.)IEEE Transactions on Information Theory, 1962