Thermodynamic analysis of a heat pump for different refrigerants
Authors:
Open Access
- 31 December 2014
- journal article
- Published by Hitte Journal of Science and Engineering in Hittite Journal of Science and Engineering
- Vol. 1 (1) , 27-36
Abstract
In this study, the air to air heat pump that was installed to a room having dimensions of 6000x4000x3800 mm, was tested between the outdoor temperatures of -5°C and 5°C for different refrigerants , namely R134a, R404A, R407C and R410A. The electric power drawn by the compressor, indoor unit and outdoor unit fans, temperatures and pressures at the state points were measured. Experiments at the same outdoor temperatures were repeated three times under the controlled conditions. Analyses of the results obtained from the experiments were carried out by the computer code that was developed by means of Engineering Equation Solver (EES-V9.172-3D). The power consumed by the compressor, heating capacity of indoor unit, the absorbing heat capacity of outdoor unit, coefficient of performance of the heat pump, suction and discharge pressures of the compressor were investigated according to the outdoor temperatures. As the outdoor air temperature increased, the power consumed by the compressor increased whereas the indoor unit and outdoor unit capacities and coefficient of performance of the heat pump decreased on average. R134a is the most fovarable refrigerants among the refrigerants under study because of consuming the least compressor power and having the highest coefficient of performanceKeywords
This publication has 4 references indexed in Scilit:
- Measured effect of airflow and refrigerant charge on the seasonal performance of an air-source heat pump using R-410AEnergy and Buildings, 2011
- An air source heat pump with an advanced cycle for heating buildings in BeijingEnergy Conversion and Management, 2011
- A ‘drop-in’ refrigerant R431A for replacing HCFC22 in residential air-conditioners and heat pumpsEnergy Conversion and Management, 2009
- Experimental performance of R432A to replace R22 in residential air-conditioners and heat pumpsApplied Thermal Engineering, 2009