Unrolling Post-Mortem 3D Fingerprints Using Mosaicking Pressure Simulation Technique
Authors:
Open Access
- 27 June 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 7, 88174-88185
Abstract
Post-mortem fingerprints are a valuable biometric used to aid in the identification of a deceased individual. However, fingerprints from the deceased undergo decomposition leading to indefinite structure when compared to ante-mortem fingerprints. Moreover, the performance of the existing two-dimensional (2D) fingerprint recognition systems is still below the expected potential. These problems arise because fingerprints are generally captured by manipulating a finger against a plane. In post-mortem fingerprint recovery, the decedent’s finger must go through several reconditioning processes to prevent the rapid onslaught of decomposition. To address these deficiencies associated with the 2D systems, three-dimensional (3D) scanning systems have been employed to capture fingerprints. 3D technology is still in its transient phase, and is limited primarily by (i) the lack of existing 3D databases, (ii) the deficiency of 3D to 2D fingerprint image mapping algorithms, (iii) the incapacity to model and recreate the 2D fingerprint capturing procedure to improve 3D-2D fingerprint verification, and (iv) the inability to apply traditional fingerprint unrolling techniques on post-mortem 3D fingerprints. This paper presents a novel method to perform postmortem 3D fingerprint unrolling and pressure simulation to produce fingerprint images that are compatible with 2D fingerprint recognition systems. The thrust of this work strives to (i) develop a correspondence between 3D touchless and contact-based 2D fingerprint images, (ii) model fingerprints with deformities to provide a viable fingerprint image for matching, and (iii) develop a Mosaic Pressure Simulation (MPS) algorithm to recreate the effects of 2D fingerprint capturing procedure.Keywords
Funding Information
- National Institute of Justice (2014-IJ-CX-K003)
This publication has 51 references indexed in Scilit:
- 3D fingerprint reconstruction system using feature correspondences and prior estimated finger modelPattern Recognition, 2014
- Influence of Skin Diseases on Fingerprint Quality and Recognition2012
- Detailed Real-Time Urban 3D Reconstruction from VideoInternational Journal of Computer Vision, 2007
- A New Method of Reproduction of Fingerprints from Corpses in a Bad State of Preservation Using LatexJournal of Forensic Sciences, 2007
- Personal Authentication Using 3-D Finger GeometryIEEE Transactions on Information Forensics and Security, 2006
- Image quality assessment: from error visibility to structural similarityIEEE Transactions on Image Processing, 2004
- An Introduction to Biometric RecognitionIEEE Transactions on Circuits and Systems for Video Technology, 2004
- Transform-based image enhancement algorithms with performance measureIEEE Transactions on Image Processing, 2001
- A practical guide to biometric security technologyIT Professional, 2001
- Fingerprint Structure Imaging Based on an Ultrasound CameraInstrumentation Science & Technology, 1999