Fabrication and Frosting Properties Study of Surface-Active Agents Coating Based on Nanoporous Aluminum Substrate
Open Access
Abstract
In order to solve the frosting and blockage problem of an air conditioning evaporator’s fin in winter, the nanoporous aluminum plates with low surface energy has been proposed in this paper, which are fabricated by an anodizing method and then modified by lauric acid. The nanoporous aluminum plates with different nanoporous diameters ranging from 15 nm to 400 nm are obtained by changing the magnitude of the oxidation current. The surface contact angle of the nanoporous aluminum plates is an important factor influencing its surface frost and condensation. The test results show that the surface contact angle is decreased with the increasing of nanoporous diameter. When the nanoporous aluminum plates are modified by lauric acid, the contact angle is proportional to the nanoporous diameter, and the maximum contact angle can reach about 171°. A set of experimental instruments has been set up to simulate the typical winter climate in northern China, and the frosting properties of the nanoporous aluminum plate’s fin is analyzed by experiment. The results show that increasing the contact angle of aluminum plates can effectively improve its anti-frosting properties. The average frosting rate of the aluminum plate with the contact angle of 60° is about 0.33 [g/(min∙m2)], which is 1.74 times that of the aluminum plate with the contact angle of 171°, whose frosting rate is about 0.19 [g/(min∙m2)]. After taking the expanded aperture processing to the aluminum plate, the diameter with 30 nm, 100 nm, 200 nm, 300 nm, and 400 nm nanoporous aluminum plates are obtained and the polished aluminum plates are also prepared for comparing. Through the test results, the nanoporous aluminum plates are shown to have anti-frosting properties, and the nanoporous aluminum plates with diameter of 300 nm are shown to have the best anti-frosting properties. The calculation mode of frosting growth is derived on the base of experimental results. This research will be helpful in indicating the potential research area of the low-carbon-emission and energy-saving technology for the researchers all over the world.Keywords
Funding Information
- National Key R&D Program of China: Low Energy Dew Point Cooling for Computing Data Centres (2016YFE0133300)
- Horizon 2020-Research and Innovation Framework Programme: Low Energy Dew Point Cooling for Computing Data Centres (734340-DEW-COOL-4-CDC-MSCA-RIS)
- Department of Science and Technology of Guangdong Province, China (2014A010106031, 2013B091500094)
This publication has 26 references indexed in Scilit:
- Effect of CVD carbon coatings on properties of SiC fibresSurface Engineering, 2017
- Coatings to prevent frostJournal of Coatings Technology and Research, 2016
- Bio-Inspired Strategies for Anti-IcingACS Nano, 2014
- Effect of contact angle on water droplet freezing process on a cold flat surfaceExperimental Thermal and Fluid Science, 2012
- Icephobic/Anti‐Icing Properties of Micro/Nanostructured SurfacesAdvanced Materials, 2012
- Drainage of frost melt water from vertical brass surfaces with parallel microgroovesInternational Journal of Heat and Mass Transfer, 2012
- Frosting and defrosting characteristics of a fin according to surface contact angleInternational Journal of Heat and Mass Transfer, 2011
- Super-hydrophobic film retards frost formationSoft Matter, 2010
- A study of frost nucleation on flat surfacesExperimental Thermal and Fluid Science, 2008
- An experimental study on minimizing frost deposition on a cold surface under natural convection conditions by use of a novel anti-frosting paint. Part I. Anti-frosting performance and comparison with the uncoated metallic surfaceInternational Journal of Refrigeration, 2006