Numerical investigation of the swirl gas angle and arc current dependence on evaporation of hafnium cathode in a plasma cutting arc
Authors:
- 26 December 2011
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 40 (2) , 497-504
Abstract
The effects of arc current and swirl gas angle on a plasma cutting arc are investigated using a 2-D thermofluid model developed for arc plasma with consideration of hafnium (Hf) cathode evaporation. Numerical modeling is extremely important to predict the erosion amount of Hf cathode for different process parameters in plasma cutting arcs. Results show that a larger swirl gas angle causes a high-temperature plasma area in front of the cathode surface shrunken in the radial direction and that the flow patterns changed to the opposite direction in front of the cathode at swirl gas angles from 12° to 30°. This change in the gas flow pattern induces Hf vapor transport along the center-axis direction to the nozzle outlet. With the increase of arc current, the whole temperature field markedly increases, and the radius of arc plasma is expanded in the radial direction. The total amount of mass loss of Hf cathode evaporation was predicted to be enhanced with increasing arc current and swirl gas angle from 12°.Keywords
This publication has 11 references indexed in Scilit:
- Plasma arc cutting: speed and cut qualityJournal of Physics D: Applied Physics, 2009
- The effect of plasma-gas swirl flow on a highly constricted plasma cutting arcJournal of Physics D: Applied Physics, 2009
- Effects of Nozzle Length and Process Parameters on Highly Constricted Oxygen Plasma Cutting ArcPlasma Chemistry and Plasma Processing, 2008
- Thermodynamic and transport properties of CO2, CO2–O2, and CO2–H2mixtures at temperatures of 300 to 30,000 K and pressures of 0.1 to 10 MPaElectrical Engineering in Japan, 2008
- Understanding Plasma Fluid Dynamics Inside Plasma Torches Through Advanced ModelingIEEE Transactions on Plasma Science, 2008
- What we know and what we do not know about plasma arc cuttingJournal of Physics D: Applied Physics, 2006
- Experimental study of an oxygen plasma cutting torch: II. Arc–material interaction, energy transfer and anode attachmentJournal of Physics D: Applied Physics, 2006
- Cathode erosion in high-current high-pressure arcJournal of Physics D: Applied Physics, 2003
- Cathode erosion rate in high-pressure arcs: influence of swirling gas flowIEEE Transactions on Plasma Science, 2002
- Numerical and experimental study of a plasma cutting torchJournal of Physics D: Applied Physics, 2001