Significant Shear Failure Difference among Additively Manufactured Polymers Using Different Techniques
Open Access
- 26 September 2022
- Vol. 14 (19) , 4028
Abstract
Because additively manufactured materials are increasingly being used in load-bearing structures, strength research has become critical. Surprisingly, numerous studies have reported the tensile strength measurements, but only a few studies have presented meaningful results for the shear strength measurements of additively manufactured polymers. Hence, this paper proposes a combined experimental and numerical investigation of a new interlayer shear strength measurement approach, and it targeted the applications of the same polyamide (PA12) specimens made with fused deposition modeling (FDM) and selective laser sintering (SLS). A necking-shaped shear specimen was developed to measure the pure shear strengths with the aid of a three-dimensional (3D) finite element analysis. The results showed that the specimens made with FDM and SLS exhibited totally different shear failure behaviors. The ultimate shear strength of the FDM-PA specimens had more than a 32% increase over that of the SLS-PA specimens. An interface mechanics assumption was employed to explore the different shear failure mechanisms with the support of a fractography analysis.Keywords
This publication has 13 references indexed in Scilit:
- 3D printing-enabled self-assembling β-nucleating agent alignment: Structural evolution and mechanical performancesPolymer, 2022
- Fused deposition modeling of thermoplastic elastomeric materials: Challenges and opportunitiesAdditive Manufacturing, 2021
- Interlayer Bonding Capability of Additively Manufactured Polymer Structures under High Strain Rate Tensile and Shear LoadingPolymers, 2021
- Fracture behavior of additively printed ABS: Effects of print architecture and loading rateInternational Journal of Solids and Structures, 2021
- Methods of enhancing strength of geopolymer produced from powder-based 3D printing processMaterials Letters, 2018
- Bond interface design for single lap joints using polymeric additive manufacturingComposite Structures, 2017
- On the visco-elasto-plastic response of additively manufactured polyamide-12 (PA-12) through selective laser sinteringPolymer Testing, 2017
- Effect of the Interfacial Stress Distribution on the Material Interfacial Shear Strength MeasurementExperimental Mechanics, 2009
- Impact failure characteristics in sandwich structuresInternational Journal of Solids and Structures, 2002
- Mixed Mode Cracking in Layered Materials1991