Flat die geometry—A note
Author:
- 1 October 1988
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 28 (19) , 1275
Abstract
Linearly tapered coat hanger dies or T‐dies are widely accepted. Nevertheless a newly proposed curvilinearly tapered coat hanger die has been shown to perform much better. It costs about the same as the other types of dies. This contribution is considered in terms of the recent literature.Keywords
This publication has 4 references indexed in Scilit:
- Residence time distribution of polymer melts in the linearly tapered coat‐hanger diePolymer Engineering & Science, 1983
- Design of coat‐hanger sheeting dies based on ratio of residence times in manifold and slotPolymer Engineering & Science, 1980
- Residence time distribution of polymer melt in the T‐diePolymer Engineering & Science, 1980
- Geometry design of a coat‐hanger die with uniform flow rate and residence time across the die widthPolymer Engineering & Science, 1979