Selection of Silica Type and Amount for Flowability Enhancements via Dry Coating: Contact Mechanics Based Predictive Approach
Authors:
- 20 July 2023
- journal article
- research article
- Published by Springer Nature in Pharmaceutical Research
- Vol. 40 (12) , 2917-2933
Abstract
Purpose To investigate the effect of dry coating the amount and type of silica on powder flowability enhancement using a comprehensive set of 19 pharmaceutical powders having different sizes, surface roughness, morphology, and aspect ratios, as well as assess flow predictability via Bond number estimated using a mechanistic multi-asperity particle contact model. Method Particle size, shape, density, surface energy and area, SEM-based morphology, and FFC were assessed for all powders. Hydrophobic (R972P) or hydrophilic (A200) nano-silica were dry coated for each powder at 25%, 50%, and 100% surface area coverage (SAC). Flow predictability was assessed via particle size and Bond number. Results Nearly maximal flow enhancement, one or more flow category, was observed for all powders at 50% SAC of either type of silica, equivalent to 1 wt% or less for both the hydrophobic R972P or hydrophilic A200, while R972P generally performed slightly better. Silica amount as SAC better helped understand the relative performance. The power-law relation between FFC and Bond number was observed. Conclusion Significant flow enhancements were achieved at 50% SAC, validating previous models. Most uncoated very cohesive powders improved by two flow categories, attaining easy flow. Flowability could not be predicted for both the uncoated and dry coated powders via particle size alone. Prediction was significantly better using Bond number computed via the mechanistic multi-asperity particle contact model accounting for the particle size, surface energy, roughness, and the amount and type of silica. The widely accepted 200 nm surface roughness was not valid for most pharmaceutical powders.Keywords
Funding Information
- Directorate for Engineering (IIP-1919037)
- National Science Foundation (IIP-2137209)
- International Fine Particle Research Institute
This publication has 52 references indexed in Scilit:
- Passivation of High-Surface-Energy Sites of Milled Ibuprofen Crystals via Dry Coating for Reduced Cohesion and Improved FlowabilityJournal of Pharmaceutical Sciences, 2013
- Applying dry powder coatings to pharmaceutical powders using a comil for improving powder flow and bulk densityPowder Technology, 2011
- Simultaneous micronization and surface modification for improvement of flow and dissolution of drug particlesInternational Journal of Pharmaceutics, 2011
- Prediction of granule packing and flow behavior based on particle size and shape analysisJournal of Pharmaceutical Sciences, 2010
- Pull-off force of coated fine powders under small consolidationPhysical Review E, 2009
- Quantifying Effects of Particulate Properties on Powder Flow Properties Using a Ring Shear TesterJournal of Pharmaceutical Sciences, 2008
- Dry particle coating for improving the flowability of cohesive powdersPowder Technology, 2005
- Investigation of compacted hydrophilic and hydrophobic colloidal silicon dioxides as glidants for pharmaceutical excipientsPowder Technology, 2004
- A simple relationship between particle shape effects and density, flow rate and Hausner RatioPowder Technology, 1985
- Cohesive forces between particles of fluid-bed catalystsPowder Technology, 1976