Hand rim configuration: effects on physical strain and technique in unimpaired subjects?
- 10 July 2003
- journal article
- clinical trial
- Published by IOP Publishing in Medical Engineering & Physics
- Vol. 25 (9) , 765-774
Abstract
Hand rim wheelchair propulsion is inefficient and physically straining. To evaluate the possibly advantageous role in this respect of three different prototype hand rim configurations (a rubber foam-coated cylindrical (II) hand rim and two profiled rubber foam-coated hand rims (wide and narrow: III, IV)), a group of 10 unimpaired subjects conducted four submaximal discontinuous wheelchair exercise tests on a computer-controlled wheelchair ergometer, thus allowing a comparison with a standard hand rim (chromium-plated round hand rim (I)). Apart from physiological measures (oxygen uptake, heart rate (HR), ventilation, mechanical efficiency (ME)), a subjective score for the rating of each of the hand rims was determined, as well as characteristics of the force application in the propulsion phase during each test condition. Timing parameters of the push and recovery phase were determined. Each exercise test was conducted with one of the four hand rim configurations in a counter-balanced order. Analysis of variance with repeated measures (hand rim configuration, power output) revealed no significant effects (P>0.05) on any of the physiological parameters and force application characteristics for the main factor 'hand rim configuration'. Only the subjective score (scale 0-10) for rating of the hand rims proved significantly different between the round rubber (7.5+/-0.53) coated hand rim-receiving the highest score-versus the narrow rubber-coated flat profiled hand rim (5.5+/-1.72). In this subject group and under the selected tasks and submaximal conditions of wheelchair propulsion, the studied hand rim configurations did not introduce critical shifts in the technique of (de-)coupling and power production in the push phase. As a consequence, no systematic shifts in ME are found among the different hand rim configurations. It is suggested that the biological constraints of the task overrule the possible effects of small design variations of the different hand rim configurations within the studied subject group and under the limited test conditions. The hand rim design characteristics may however be much more critical in (1) experienced wheelchair users, (2) especially those subjects with a limited hand-arm and/or trunk function and/or (3) under much more extreme conditions of daily wheelchair ambulation (i.e. turning, stopping/starting, negotiating a slope) or during peak performance. These issues clearly require continued future research. As such, the current results can be viewed as preliminary results only.Keywords
This publication has 24 references indexed in Scilit:
- Load on the shoulder in low intensity wheelchair propulsionClinical Biomechanics, 2002
- Consequence of feedback-based learning of an effective hand rim wheelchair force production on mechanical efficiencyClinical Biomechanics, 2002
- Biomechanics of Manual Wheelchair Propulsion in ElderlyAmerican Journal of Physical Medicine & Rehabilitation, 2002
- Alternative Modes of Manual Wheelchair AmbulationAmerican Journal of Physical Medicine & Rehabilitation, 2001
- Comparison of three different models to represent the wrist during wheelchair propulsionIEEE Transactions on Neural Systems and Rehabilitation Engineering, 2001
- Force direction in manual wheel chair propulsion: balance between effect and costClinical Biomechanics, 2000
- The effect of wheelchair handrim tube diameter on propulsion efficiency and force application (tube diameter and efficiency in wheelchairs)IEEE Transactions on Rehabilitation Engineering, 1996
- Quasi-static analysis of muscle forces in the shoulder mechanism during wheelchair propulsionJournal of Biomechanics, 1996
- Upper limb function in persons with long term paraplegia and implications for independence: Part ISpinal Cord, 1994
- Load on the upper extremity in manual wheelchair propulsionJournal of Electromyography and Kinesiology, 1991