Real-time Detection Approach: Applied To Potential Transformer-based Over-voltage Monitoring
Authors:
- 1 December 2019
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Abstract
Potential transformer(PT)-based over-voltage monitoring has the advantage of low cost and safety. However, signal distortion due to poor frequency characteristics makes overvoltage detection difficult. This paper introduces a software-based real-time overvoltage detection approach. First, the voltage signal data continuously acquired at high speed are taken as input, and the feature point sequence(FPS) is obtained by extracting local extremum points of the signal. Then, based on the FPS, characteristic parameters such as peak voltage (PV), maximum waveform gradient (GM), number of pulses (PN), and waveform symmetry coefficient (WSC) are calculated. Finally, these feature parameters are fused to obtain a normalized overvoltage detection coefficient (ODC). The ODC is compared to a set threshold to determine if an overvoltage has occurred. Multithreaded programming techniques are used for real-time detection of over-voltages. The monitoring system using this approach has been successfully applied.Keywords
This publication has 6 references indexed in Scilit:
- A Smart Online Over-Voltage Monitoring and Identification SystemEnergies, 2011
- Online lightning and internal overvoltages monitoring system in 10 kV distribution networksEuropean Transactions on Electrical Power, 2010
- A High-Frequency Circuit Model of a Potential Transformer for the Very Fast Transient Simulation in GISIEEE Transactions on Power Delivery, 2008
- A novel method to identify the inrush current based on waveform longitudinal symmetry coefficient for transformer protection2004
- A new method of transient overvoltage monitoring for substation2003
- High-divider-ratio fast-response capacitive dividers for high-voltage pulse measurementsIEEE Transactions on Industry Applications, 2000