Tunable 3D-Printed Coaxial-Cavity Filters with Mixed Electromagnetic Coupling
- 1 July 2019
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1703-1704
Abstract
This paper reports on 3D-printed coaxial-cavity bandpass filters (BPFs) with multiple levels of transfer function tunability. These include: i) center frequency tuning, ii) bandwidth (BW) tuning and iii) intrinsic switching-off. They are based on a new type of mixed electromagnetic coupling that facilitates the realization of a tunable transmission zero (TZ) that is exploited for the tuning of the BPF’s BW and its out-of-band isolation. Center frequency adaptivity is obtained by incorporating linear actuators on top of the cavity walls. A proof-of-concept two-pole/one-TZ BPF with tunable frequency between 1.3-2.2 GHz and BW between 59-98 MHz was manufactured and measured.Keywords
This publication has 5 references indexed in Scilit:
- An X-band lightweight 3-D printed slotted circular waveguide dual-mode bandpass filter2017
- A Lightweight 3-D Printed $X$ -Band Bandpass Filter Based on Spherical Dual-Mode ResonatorsIEEE Microwave and Wireless Components Letters, 2016
- All-Silicon Technology for High-$Q$ Evanescent Mode Cavity Tunable Resonators and FiltersJournal of Microelectromechanical Systems, 2013
- High-$Q$ Tunable Microwave Cavity Resonators and Filters Using SOI-Based RF MEMS TunersJournal of Microelectromechanical Systems, 2010
- Precision Fabrication Techniques and Analysis on High-$Q$Evanescent-Mode Resonators and Filters of Different GeometriesIEEE Transactions on Microwave Theory and Techniques, 2004