A Fault-Tolerant Direct Controlled PMSG Drive for Wind Energy Conversion Systems
- 12 March 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 61 (2) , 821-834
Abstract
Reliability and availability levels are crucial aspects for assessing the economic viability of wind energy conversion systems. Therefore, fault-tolerant systems can make a valuable contribution. This paper presents a fault-tolerant permanent-magnet synchronous generator (PMSG) drive employing new direct control techniques. For postfault operation, a direct power control (DPC) of a four-switch three-phase converter and a direct torque control of a three-switch three-phase rectifier are proposed. Switching tables are theoretically formulated for both control techniques. Two alternative tables are obtained for the DPC of the grid-side converter, permitting the choice between implementation simplicity and enhanced performance. All necessary reconfigurations to handle open-circuit faults are triggered by a reliable fault diagnostic method, which has a low computational demand, without requiring additional measurements. Experimental results are presented, demonstrating the feasibility of the proposed fault-tolerant PMSG drive.Keywords
This publication has 45 references indexed in Scilit:
- Investigation on Switching Patterns of Direct Power Control Strategies for Grid-Connected DC–AC Converters Based on Power Variation RatesIEEE Transactions on Power Electronics, 2011
- Influence and Compensation of Inverter Voltage Drop in Direct Torque-Controlled Four-Switch Three-Phase PM Brushless AC DrivesIEEE Transactions on Power Electronics, 2011
- Table-Based Direct Power Control: A Critical Review for Microgrid ApplicationsIEEE Transactions on Power Electronics, 2010
- A Simple Method to Reduce Torque Ripple in Direct Torque-Controlled Permanent-Magnet Synchronous Motor by Using Vectors With Variable Amplitude and AngleIEEE Transactions on Industrial Electronics, 2010
- Analysis and design of new switching table for direct power control of three-phase PWM rectifier2008
- Direct Torque Control of PWM Inverter-Fed AC Motors—A SurveyIEEE Transactions on Industrial Electronics, 2004
- Novel flux and torque control of induction motor drive using four switch three phase inverter2002
- Direct power control of PWM converter without power-source voltage sensorsIEEE Transactions on Industry Applications, 1998
- DC link imbalance compensation in four-switch inverterAC motor drivesElectronics Letters, 1997
- A New Quick-Response and High-Efficiency Control Strategy of an Induction MotorIEEE Transactions on Industry Applications, 1986