Comparison of Plain Piezoceramics and Inter-digital Transducer for Crack Detection in Plates
Authors:
- 1 September 2007
- journal article
- research article
- Published by SAGE Publications in Journal of Intelligent Material Systems and Structures
- Vol. 18 (9) , 949-961
Abstract
The use of piezoceramics transducers (PZTs) for non-destructive evaluation (NDE) via Lamb waves has attracted significant attention recently in view of its favorable sensing and actuating characteristics. A comprehensive strategy to locate and trace the geometry of cracks in plates has been developed earlier using either plain piezoceramics or interdigital transducers (IDTs) based on time of flight analysis of incident and reflected waves. In this article, a comparison of the two techniques is presented based on results from laboratory experiments. Cracks of differing geometries, namely, linear crack, curved crack, and multiple cracks, on aluminum plates are considered. Comparisons of their detection capabilities are also made on a crack of fine width (220 μm) and cracks filled with impurities such as grease, araldite epoxy, metallic epoxy, and spray paint. Both techniques are applied in the case of weld where a notch is induced in the weld on an aluminum plate and the results obtained for the weld with and without the notch are compared. The results for all cases considered show that both the plain piezoceramics and IDT techniques can successfully detect and locate the cracks. Plain piezoceramics are able to provide accurate detection for linear, nonlinear, and piecewise linear cracks, and notch in weld. The geometries are traced with reasonable accuracy. However, IDT has been shown to be more accurate, procedurally simpler, and is an efficient alternative to plain piezoceramics.Keywords
This publication has 17 references indexed in Scilit:
- Detection of cracks in plates using piezo-actuated Lamb wavesSmart Materials and Structures, 2004
- Detecting anomalies in beams and plate based on the Hilbert–Huang transform of real signalsSmart Materials and Structures, 2003
- Analytical solution of excitation of Lamb waves in plates by inter-digital transducersProceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2003
- Effects of local stiffness changes and delamination on Lamb wave transmission using surface-mounted piezoelectric transducersComposite Structures, 2002
- Wind tunnel testing of a Mach-scaled rotor model with trailing-edge flapsSmart Materials and Structures, 2001
- Radome health monitoring with Lamb waves: experimental approachNDT & E International, 2000
- The rapid monitoring of structures using interdigital Lamb wave transducersSmart Materials and Structures, 2000
- Crack Detection in Metallic Structures Using Piezoceramic SensorsKey Engineering Materials, 1999
- Active Damage Detection in Filament Wound Composite Tubes Using Built-In Sensors and ActuatorsJournal of Intelligent Material Systems and Structures, 1997
- Comparison of Lamb waves and pulse echo in detection of near-surface defects in laminate platesNDT & E International, 1995