Surface chemical analysis of poly(ε‐caprolactone)–perfluoropolyether–poly(ε‐caprolactone) triblock copolymers by X‐ray photoelectron spectroscopy
- 18 July 2003
- journal article
- research article
- Published by Wiley in Polymer International
- Vol. 52 (8) , 1262-1274
Abstract
The air‐side surface composition of a series of poly(ε‐caprolactone)–perfluoropolyether–poly(ε‐caprolactone) triblock copolymers with different compositions and block lengths have been studied by angle‐dependent X‐ray photoelectron spectroscopy (XPS). The weight percentage of the perfluoropolyether (PFPE) and polycaprolactone (PCL) blocks, and ethylene oxide linker (RH) has been calculated in different ways: from C1s, O1s and F1s photoemission peaks and by line fitting of the C1s and O1s envelopes. The atomic sensitivity factors and the parameters used to fit the peak envelopes have been experimentally determined using some reference materials. A critical discussion of the different methods used in the surface characterization and the degradation of PFPE segments, induced by irradiation beam, have been also reported. A large excess of PFPE with respect to the bulk composition was observed in all samples, and the angular dependence of the XPS signal demonstrated that the content of the fluorinated block segment increased by decreasing the sampling depth. The PFPE surface concentration was also decreased by increasing the PCL/PFPE ratio, but the surfaces of the samples were still dominated by PFPE segments for copolymers with a bulk PFPE composition lower than 10%. Moreover, copolymers with similar PCL/PFPE bulk ratios but with different PFPE block lengths, showed similar PFPE surface composition when the number‐average molecular weight (Mn) was 2000 and 3200 g mol−1, while that observed for copolymers containing PFPE block with Mn 900 g mol−1 was lower. Copyright © 2003 Society of Chemical IndustryKeywords
This publication has 22 references indexed in Scilit:
- Investigation of the Water-Induced Reorganization of Polycaprolactone−Poly(fluoroalkylene oxide)−Polycaprolactone Triblock Copolymer Films by Angle-Dependent X-ray Photoelectron SpectroscopyMacromolecules, 2002
- Poly(ϵ-caprolactone)-poly(fluoroalkylene oxide)-poly(ϵ-caprolactone) block copolymers. 2. Thermal and surface propertiesPolymer, 2001
- APPLICATIONS OF X-RAY PHOTOELECTRON SPECTROSCOPY AND STATIC SECONDARY ION MASS SPECTROMETRY IN SURFACE CHARACTERIZATION OF COPOLYMERS AND POLYMERS BLENDSReviews in Chemical Engineering, 2000
- Poly(ε-caprolactone)−Poly(fluoroalkylene oxide)−Poly(ε-caprolactone) Block Copolymers. 1. Synthesis and Molecular CharacterizationMacromolecules, 1999
- Linear perfluoropolyether difunctional oligomers: chemistry, properties and applicationsJournal of Fluorine Chemistry, 1999
- XPS Study on Surface Segregation in Poly(ethylene-iso/terephthalate)−Perfluoropolyether Block CopolymersMacromolecules, 1998
- Surface Modification of Polymers by Blending Siloxane Block CopolymersMacromolecules, 1994
- Surface Study of Diblock Copolymers of Poly(dimethylsiloxane) and Nylon-6 by Electron Spectroscopy for Chemical AnalysisMacromolecules, 1994
- Surface spectroscopic studies of polymer surfaces and interfaces: 2. Poly(tetramethyl-P-silphenylenesiloxanepoly(dimethylsiloxane) block copolymersPolymer, 1987
- Application of ESCA to polymer chemistry. VIII. Surface structures of AB block copolymers of polydimethylsiloxane and polystyreneJournal of Polymer Science: Polymer Chemistry Edition, 1976