Probing the Interplay between Mo Back Contact Layer Deposition Condition and MoSe2 Layer Formation at the CIGSe/Mo Hetero-Interface
Authors:
- Fazliyana ‘Izzati Za’abarFZFazliyana ‘Izzati Za’abar
- Ahmad Wafi Mahmood ZuhdiAZAhmad Wafi Mahmood Zuhdi
- Camellia DoroodyCamellia Doroody
- Puvaneswaran ChelvanathanPuvaneswaran Chelvanathan
- Yulisa YusoffYYYulisa Yusoff
- Siti Fazlili AbdullahSASiti Fazlili Abdullah
- Mohd. Shaparuddin BahrudinMBMohd. Shaparuddin Bahrudin
- Wan Sabeng Wan AdiniWAWan Sabeng Wan Adini
- Ibrahim AhmadIAIbrahim Ahmad
- Wan Syakirah Wan AbdullahWAWan Syakirah Wan Abdullah
- Nowshad AminNowshad Amin
Open Access
Abstract
The effect of Mo thin film deposition power in DC sputtering on the formation of a MoSe2 interfacial layer grown via the annealing of CIGSe/Mo precursors in an Se-free atmosphere was investigated. A Mo layer was deposited on glass substrates using the DC magnetron sputtering method. Its electrical resistivity, as well as its morphological, structural, and adhesion characteristics, were analyzed regarding the deposition power. In the case of thinner films of about 300 nm deposited at 80 W, smaller grains and a lower volume percentage of grain boundaries were found, compared to 510 nm thick film with larger agglomerates obtained at 140 W DC power. By increasing the deposition power, in contrast, the conductivity of the Mo film significantly improved with lowest sheet resistance of 0.353 Ω/square for the sample deposited at 140 W. Both structural and Raman spectroscopy outputs confirmed the pronounced formation of MoSe2, resulting from Mo films with predominant (110) orientated planes. Sputtered Mo films deposited at 140 W power improved Mo crystals and the growth of MoSe2 layers with a preferential (103) orientation upon the Se-free annealing. With a more porous Mo surface structure for the sample deposited at higher power, a larger contact area developed between the Mo films and the Se compound was found from the CIGSe film deposited on top of the Mo, favoring the formation of MoSe2. The CIGSe/Mo hetero-contact, including the MoSe2 layer with controlled thickness, is not Schottky-type, but a favourable ohmic-type, as evaluated by the dark I-V measurement at room temperature (RT). These findings support the significance of regulating the thickness of the unintentional MoSe2 layer growth, which is attainable by controlling the Mo deposition power. Furthermore, while the adhesion between the CIGSe absorber layer and the Mo remains intact, the resistance of final devices with the Ni/CIGSe/Mo structure was found to be directly linked to the MoSe2 thickness. Consequently, it addresses the importance of MoSe2 structural properties for improved CIGSe solar cell performance and stability.Keywords
Funding Information
- Tenaga Nasional Berhad Seeding Fund (U-TE-RD-18-01)
This publication has 55 references indexed in Scilit:
- Two‐Dimensional Molybdenum Trioxide and DichalcogenidesAdvanced Functional Materials, 2013
- Determining factor of MoSe2 formation in Cu(In,Ga)Se2 solar CellsSolar Energy Materials and Solar Cells, 2012
- Effect of sputtering process parameters on film properties of molybdenum back contactSolar Energy Materials and Solar Cells, 2012
- Electrical and morphological properties of low resistivity Mo thin films prepared by magnetron sputteringBrazilian Journal of Physics, 2006
- Spectroscopic investigation of the deeply buried Cu(In,Ga)(S,Se)2∕Mo interface in thin-film solar cellsThe Journal of Chemical Physics, 2006
- Microstructural and diffusion properties of CIGS thin film solar cells fabricated using transparent conducting oxide back contactsThin Solid Films, 2005
- Formation and characterisation of MoSe2 for Cu(In,Ga)Se2 based solar cellsThin Solid Films, 2005
- Characterization of Cu(In,Ga)Se2/Mo Interface in CIGS Solar CellsMRS Proceedings, 1997
- High-pressure Raman spectroscopy in the layered materials -Mo, -Mo, and -MoPhysical Review B, 1982
- Electrical-Resistivity Model for Polycrystalline Films: the Case of Arbitrary Reflection at External SurfacesPhysical Review B, 1970