Mechanical properties of molding compounds (MCs) under different moisture conditions and in a wide temperature range
Authors:
- 30 June 2004
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 593-598
Abstract
In this work, fracture toughness and flexural properties including flexural modulus, flexural stress/strain of 2 molding compounds GMC-1 and GMC-2 were investigated in a temperature range from -60/spl deg/C to 260/spl deg/C, whereby three-point-bending method was applied to all tests. To observe the moisture effect on those mechanical properties, specimens were soaked under 85/spl deg/C/85%RH conditions for 168 hours following the moisture reflow standards (for moisture tests) or baked for at least 24 hours (for dry tests) before tests. The obtained results are then compared with each other. It is seen that at high temperature, rupture stress of the 2 MCs at 85/spl deg/C/85% RH condition could be 40%-50% lower than those at dry conditions. The remarkable reduction of material strength will largely promote the failure in the packages considering that modulus change does not change significantly the stress level. It is also found that using the material data for GMC-1 provided by vendor could underestimate maximum Von Mises stress by around 15% at high temperature. Similarly, fracture toughness decreases greatly with temperature and moisture content. At 260/spl deg/C, maximum Von Mises stress could be reduced by 40% due to the moisture take-up change from dry to wet (MSL1).Keywords
This publication has 6 references indexed in Scilit:
- Advanced moisture diffusion modeling and characterisation for electronic packaging2003
- Hygroscopic swelling and sorption characteristics of epoxy molding compounds used in electronic packagingIEEE Transactions on Components and Packaging Technologies, 2003
- Moisture-induced interfacial delamination growth in plastic IC packages during solder reflow2002
- Evaluation of interface delamination in IC packages by considering swelling of the molding compound due to moisture absorption2002
- Mechanics of interfacial delamination under hygrothermal stresses during reflow soldering2002
- The mechanics and impact of hygroscopic swelling of polymeric materials in electronic packaging2002