Performance of a Scraped‐Surface Heat Exchanger Under Ultra High Temperature Conditions: A Dimensional Analysis
Authors:
- 1 March 1982
- journal article
- research article
- Published by Wiley in Journal of Food Science
- Vol. 47 (2) , 619-625
Abstract
Performance characteristics of a pilot‐scale scraped‐surface heat exchanger (Contherm Model 6 × 2) under UHT operating conditions were evaluated. Outlet temperature and overall heat transfer coefficient (U) were significantly affected by rotational speed of the blades, mass flow rate of feed, feed inlet temperature, steam pressure and solids content of the model low‐acid liquid food (soy extracts). The scraping action of the blades greatly improved the performance up to about 350 rpm; higher blade speeds had little or no effect and sometimes decreased U values. Application of dimensionless models showed that the effect of axial Reynolds number (Re A ) on the Nusselt number was more significant in the turbulent regime (Re A > 1800), while rotational Reynolds number above 10 5 had a significant effect at all values of Re A between 1200 and 3700. At very high values of the Taylor number (> 10 10 ) when laminar axial flow conditions prevailed, Nusselt number decreased with increase in rotational Reynolds number.Keywords
This publication has 15 references indexed in Scilit:
- HEAT TRANSFER IN A VERTICAL, LIQUID‐FULL SCRAPED‐SURFACE HEAT EXCHANGER. APPLICATION OF THE PENETRATION THEORY AND WILSON PLOTS MODELSJournal of Food Process Engineering, 1982
- ULTRAFILTRATION OF SOYBEAN WATER EXTRACTS: PROCESSING CHARACTERISTICS AND YIELDSJournal of Food Science, 1979
- The stability of viscous axial flow in an annulus with a rotating inner cylinderProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1977
- The radial transfer of mass and momentum in an axial fluid stream between coaxial rotating cylinders—I experimental measurementsChemical Engineering Science, 1969
- Heat transfer on scraped walls in the laminar and transitional regionsCollection of Czechoslovak Chemical Communications, 1968
- Residence-Time Distribution in a Swept-Surface Heat ExchangerTransactions of the ASAE, 1967
- Heat transfer on scraped wallsCollection of Czechoslovak Chemical Communications, 1966
- Heat transfer across a scraped surfaceThe Canadian Journal of Chemical Engineering, 1963
- Measurements of Diabatic Flow in an Annulus With an Inner Rotating CylinderJournal of Heat Transfer, 1962
- Heat Transfer in the VotatorIndustrial & Engineering Chemistry, 1944