Simplifying emissions modelling from wildland fires: laboratory-scale emission factors are independent of fine woody debris fuel load
Open Access
- 22 January 2025
- journal article
- research article
- Published by CSIRO Publishing in International Journal of Wildland Fire
- Vol. 34 (1)
Abstract
Background: Air quality modelling of smoke from wildfires requires knowledge of emission factors and how these vary. Aims: Experimental fires were used to test the variation of emission factors with fuel load to improve a smoke forecasting model. Methods: Gas and particle-phase chemical composition of smoke plumes from laboratory-scale fires was measured with different fuel loads and at different stages of fire progression. Key results: Different fine woody debris loads had no significant effect on the emission factors. In contrast, different stages of the fire produced significant differences in emission factors. The lowest emission factors for most species (except carbon dioxide) were observed during the flaming fire front, which accounted for half the total emissions. Importantly, we found that emission ratios relative to carbon monoxide were consistent across different fuel loads and throughout the fire’s progression. Conclusions: By modelling the modified combustion efficiency, it is possible to simultaneously model the emissions of carbon monoxide and the emissions of nearly all other pollutants throughout the progression of a fire. Implications: The emissions of carbon monoxide, fine particulate matter and other key pollutants all scale with the intensity of the fire, simplifying the task of modelling these emitted pollutants downwind of prescribed fires.Keywords
Funding Information
- Department of Environment, Land, Water and Planning, State Government of Victoria
- NSW Department of Planning and Environment (Bushfire and Natural Hazards Research Centre)
This publication has 35 references indexed in Scilit:
- Improving reporting of national greenhouse gas emissions from forest fires for emission reduction benefits: An example from AustraliaEnvironmental Science & Policy, 2019
- Investigation of mercury emissions from burning of Australian eucalypt forest surface fuels using a combustion wind tunnel and field observationsAtmospheric Environment, 2019
- Effect of woody debris on the rate of spread of surface fires in forest fuels in a combustion wind tunnelForest Ecology and Management, 2018
- Emission factors of trace gases and particles from tropical savanna fires in AustraliaJournal of Geophysical Research: Atmospheres, 2017
- Inside the Inferno: Fundamental Processes of Wildland Fire BehaviourCurrent Forestry Reports, 2017
- Inside the Inferno: Fundamental Processes of Wildland Fire BehaviourCurrent Forestry Reports, 2017
- Impact of the New South Wales fires during October 2013 on regional air quality in eastern AustraliaAtmospheric Environment, 2016
- Ambient organic carbon to elemental carbon ratios: Influence of the thermal–optical temperature protocol and implicationsScience of The Total Environment, 2014
- A contractionless, low-turbulence wind tunnel for the study of free-burning firesExperimental Thermal and Fluid Science, 2013
- Thermal decomposition and combustion chemistry of cellulosic biomassAtmospheric Environment, 2012