Cathodic Hydrogen Absorption and Severe Embrittlement in a High Strength Steel
Author:
- 1 February 1970
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 26 (3) , 105-110
Abstract
Hydrogen absorption and consequent embrittlement are studied in hardened low-alloy steel tensile specimens after electrolytic hydrogenation in an aqueous solution of 4% H2SO4 containing arsenic. A critical arsenic content greater than 0.5 mg/liter is needed to cause poisoning. Saturation with hydrogen at a level of 5 to 6 wt ppm is readily achieved but causes a reduction in true fracture stress from 385,000 psi to as low as 35,000 psi. Much of this embrittlement is recovered when the specimens are degassed, but some permanent damage remains in the form of near-surface cracks, many of which are associated with inclusions. These cracks develop during cathodic electrolysis. Hydrogen absorption is much more rapid than is degassing at room temperature. These effects are consistent with a picture of hydrogen migration and embrittlement involving entrapment of hydrogen gas at internal interfaces.Keywords
This publication has 6 references indexed in Scilit:
- The diffusion and trapping of hydrogen in steelActa Metallurgica, 1970
- Absorption of Hydrogen by Cathodically Protected SteelCorrosion, 1968
- Some Observations Regarding the Present Status of Measurements of the Diffusion Coefficients of Hydrogen in Iron and Mild SteelJournal of Applied Physics, 1958
- Mass Spectrometer Measurements of the Diffusion Coefficient of Hydrogen in Steel in the Temperature Range of 25°–90°CJournal of Applied Physics, 1958
- Behavior of Hydrogen in Steel During and After Immersion in AcidCorrosion, 1949
- Die Diffusion des Wasserstoffs durch eine EisenkathodeRecueil des Travaux Chimiques des Pays-Bas, 1930