Investigation on the Dependence of Directional Torsion Measurement on Multimode Fiber Geometry
- 18 February 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 40 (12) , 3997-4002
Abstract
The torsion measurement and torsion direction discrimination characteristics of a multimode fiber (MMF) geometry in a singlemode-multimode-singlemode (SMS) fiber structure are investigated theoretically and experimentally. Three different geometries of MMFs, including circular symmetric MMF, axisymmetric MMF, and asymmetric MMF were fabricated based on a fiber polishing technique. The torsion response characteristics of a MMF depends on the birefringence within the MMF, as birefringence is related to the twist rate of the fiber. The experimental results demonstrate that the unpolished MMF with a circular asymmetric refractive index (RI) distribution has no wavelength response to torsion, and the single-side polished MMF with an axisymmetric RI distribution can measure torsion, but it does not have the ability to discriminate torsion direction. It is found that an MMF section with two polished surfaces at an angle to each other results in a departure from the symmetrical RI distribution, which introduces elliptical birefringence into the MMF. As a result, directional torsion measurement is achieved with sensitivities of 0.162 nm/(rad/m) clockwise and −0.139 nm/(rad/m) counterclockwise. The MMF geometry presented provides a new approach to torsion direction discrimination and shows good application potential in practical torsion vector measurement.Keywords
Funding Information
- National Natural Science Foundation of China (61935006, 62090062)
- Natural Science Foundation of Heilongjiang Province (LH2020F028)
- Shenzhen Municipal Fundamental Research Program (JCYJ20190808173619062)
- Higher Education Discipline Innovation Project (B13015)
- Harbin Engineering University
- Heilongjiang Touyan Innovation Team Program
- Science Foundation Ireland through the Centres Research Program (SFI/12/RC/2302_P2)
This publication has 30 references indexed in Scilit:
- Highly sensitive twist sensor employing Sagnac interferometer based on PM-elliptical core fibersOptics Express, 2015
- Optical fiber magnetic field sensor based on single-mode–multimode–single-mode structure and magnetic fluidOptics Letters, 2013
- Temperature and twist characteristics of cascaded long-period fiber gratings written in polarization-maintaining fibersJournal of Optics, 2012
- Ultrahigh-sensitivity temperature fiber sensor based on multimode interferenceApplied Optics, 2012
- High-sensitivity, evanescent field refractometric sensor based on a tapered, multimode fiber interferenceOptics Letters, 2011
- Investigation of single-mode–multimode–single-mode and single-mode–tapered-multimode–single-mode fiber structures and their application for refractive index sensingJournal of the Optical Society of America B, 2011
- Experimental demonstration of a simple displacement sensor based on a bent single-mode–multimode–single-mode fiber structureMeasurement Science and Technology, 2011
- Highly sensitive fiber-optic torsion sensor based on an ultra-long-period fiber gratingOptics Communications, 2006
- Torsion characteristics of long-period fiber gratings induced by high-frequency CO2 laser pulsesJournal of the Optical Society of America B, 2005
- A torsion sensor made of a corrugated long period fibre gratingMeasurement Science and Technology, 2001