Optimised cathodic protection design for maximum bond performance in reinforced concrete
- 18 April 2018
- journal article
- research article
- Published by Wiley in Materials and Corrosion
- Vol. 69 (9) , 1151-1162
Abstract
The influence of the long‐term effects of impressed current cathodic protection (ICCP) on the bond strength is investigated. A total of 16 pull‐out specimens were divided into four series and the steel bars pre‐corroded to target degrees of 0% (control), 1, 2 and 5% weight loss. Four levels of ICCP current density ranging from approximately 0 (control) to over 1000 μA/cm2were applied to each series. These are considerably higher than the levels typically used in practice, which rarely exceed 2 μA/cm2, but were used to replicate long‐term application within a reasonable timescale. Following pull‐out tests, the values of bond load were determined. The analysis accounts for the accelerated ICCP by relating the total charge to the steel reinforcement in coulombs (current x time) to the bond values and migration of chloride ions. The results show that although some loss in bond is evident from the ICCP, an optimised current density can be applied to a real structure without affecting the as‐designed bond strength in the long‐term e.g. ≤0.65 μA/cm2for an ICCP duration of 70 years. Application of the same current density reduces the chloride concentration from around the steel irrespective of the degree of corrosion.Keywords
This publication has 11 references indexed in Scilit:
- Near-surface mounted carbon fibre rod used for combined strengthening and cathodic protection for reinforced concrete structuresStructure and Infrastructure Engineering, 2015
- Dual function carbon fibre fabric strengthening and impressed current cathodic protection (ICCP) anode for reinforced concrete structuresMaterials and Structures, 2014
- Chloride induced reinforcement corrosion: Rate limiting step of early pitting corrosionElectrochimica Acta, 2011
- Steel corrosion and service life of reinforced concrete structuresStructure and Infrastructure Engineering, 2008
- Effect of under-reinforcement on the flexural strength of corroded beamsMaterials and Structures, 2007
- A study of the bond degradation of rebar due to cathodic protection currentCement and Concrete Research, 2002
- Cathodic protection and cathodic preventionConstruction and Building Materials, 1996
- Effect of reinforcement corrosion on bond strengthConstruction and Building Materials, 1996
- Pull-out and bond degradation of steel rebars in ECE concreteCement and Concrete Research, 1996
- Cathodic protection of reinforced concreteAnti-Corrosion Methods and Materials, 1995