Prediction of air/oil exit flows in a commercial aero-engine bearing chamber
Authors:
- 1 March 2006
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
- Vol. 220 (3) , 197-202
Abstract
An understanding and optimization of three-dimensional air/oil flows in aero-engine transmission systems forms an integral part of future designs. This especially applies to bearing chambers, which contain a complex two-phase flow formed by the interaction of sealing airflows and lubrication oil. A critical design quantity is the composition of the liquid (oil) and gas (air) phases in the exit flows. Using a previously validated numerical model, the air/oil flow in a commercial bearing chamber is computed with particular focus on the flow exiting the chamber. The division of oil exiting the chamber through the vent and scavenge ports is determined for three shaft speeds and two configurations of the vent port. Comparison with available experimental data shows that consistent trends are predicted, but further model development is necessary in the vicinity of the scavenge port.Keywords
This publication has 8 references indexed in Scilit:
- Influence of Operating Condition and Geometry on the Oil Film Thickness in Aero-Engine Bearing Chambers2004
- A Numerical Model for Oil Film Flow in an Aero-Engine Bearing Chamber and Comparison With Experimental Data2004
- Internal Bearing Chamber Wall Heat Transfer as a Function of Operating Conditions and Chamber GeometryJournal of Engineering for Gas Turbines and Power, 2000
- Two-dimensional shallow water equations by composite schemesInternational Journal for Numerical Methods in Fluids, 1999
- Local and Mean Heat Transfer Coefficients Along the Internal Housing Walls of Aero Engine Bearing Chambers1997
- Two-Phase Air/Oil Flow in Aero Engine Bearing Chambers: Characterization of Oil Film FlowsJournal of Engineering for Gas Turbines and Power, 1996
- Analysis of the Oil Film on the Inside Surface of an Aero-Engine Bearing Chamber Housing1996
- Influence of High Rotational Speeds on Heat Transfer and Oil Film Thickness in Aero-Engine Bearing ChambersJournal of Engineering for Gas Turbines and Power, 1994